Question about Linksys by Cisco WAP610N Wireless-N Access Point with Dual-Band

1 Answer

Wap 610n - Linksys by Cisco WAP610N Wireless-N Access Point with Dual-Band

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Just no the defauld ip address for wap 610n

Posted on Feb 02, 2011

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Linksys router not recognize internet

Make sure your router's WAN port is set to dynamic IP. If the light on the front doesn't glow/blink for the WAN port, try a different cable. If a different cable doesn't work it's probably toast. :( This problem appears to be directly linked to the relationship between the WAN port and the modem. Given that the devices can connect to the router, but not internet, it has to be the WAN. Sometimes if the modem goes out it will send too much voltage through to the router and fry the WAN. Had that happen to my parents router. If the above doesn't "fix ya" then try a different router.

Worst case, you might have to put a wireless card in your PC and bridge the modem (wired connection) to the wireless card and broadcast for your wireless devices. At least until you get a new router.

Aug 02, 2013 | Dell Computers & Internet

1 Answer

How to reset wireless password on linksys wrt 610n

You can get the manual here
You can reset holding the reset button on the back of the router for 5 seconds, or refer to page 32 of the manual

Nov 03, 2011 | Linksys Simultaneous DualN Band Wireless...

1 Answer

Access point wap 610n constantly rebooting in every 10 minutes

Unfortunately you will likely need to replace the router. it sounds like the firmware is completely shot.

Jul 21, 2011 | Linksys by Cisco WAP610N Wireless-N Access...

2 Answers

Tell me some web adress of mobile web

  • WAP Car locate
  • WAP Autosport
  • WAP Checkaprice
  • Wap Dress Smart
  • Wap Email from Breathe
  • Wap Games
  • Wap Doctor for those on the GO
  • Wap Advice on health, careers, money, Life
  • Wap Stocks & Shares on the move
  • Wap News & Weather
  • Wap Guardian
  • Wap Jokes
  • Wap Mystery on the Move
  • Wap First Direct Access
  • WAP Hotel Guide
  • Wap Lastminute.com
  • Loot WAP Flats
  • WAP Metaprices
  • WAP Money Extra
  • Wap 10 best links
  • Wap Multimap
  • WAP Online Weather
  • WAP Parker Car Prices
  • WAP Railtrack
  • Wap Stepstone Recruitment
  • Wap UK Invest
  • WAP UK Banking
  • WAP Parker Car Prices
  • WAP Wether Online
  • WAP CNET Tech Centre
  • Jan 12, 2011 | HTC P3650 Cell Phone

    1 Answer

    We believe the problem with our LaserJet 5000 GN is the JetDirect 610N network connection on the back. It prints its own internal documents just fine, so we know it's not that. And the network itself seems...

    New Part Number is J7934A it is newer version and costs about $75.00 . To test the jet direct, press menu and then information, print the configuration page, if more then 1 sheet comes out 1 will be for the jet direct if this prints there is nothing wrong with the Jet Direct. however if you are printing through the network and you are getting any type of special characters like $%^ it is most likely a driver issue, uninstall the printer and reinstall using PCL 6. You can go to HP's wesite for driver support. Hope this helps.

    Jan 03, 2011 | HP JetDirect 610N Print Server

    1 Answer

    I have both green light next to the rj45 on my jet direct 610n, but my jet direct doe not show when I print the configuration page, I tried cold reset didn't help. Any idea howni might be able to...

    If your JetDirect Ethernet card does not show up on the configuration page then the JetDirest is bad. This is somewhat common with the 610N cards. You will need a new card. They are cheap to buy just about anywhere including Ebay. I have replaced dozens of them over the years.

    Sep 12, 2010 | HP LaserJet 4100tn Printer

    1 Answer

    I would like to know where can I find a manual that clearly states how to change and refill the toner in the Samsung CLP 610n

    User manual and quick guide available here

    Dec 21, 2009 | Samsung CLP-600N Laser Printer

    1 Answer

    My Compaq Evo 610n does not charge. It is not the charger. It will not operate with taking the battery out and using the charger.

    You probably need a battery. If not there's more wrong in the unit itself - and probably needs to go to a repair shop.

    Jul 07, 2009 | Compaq CPQ/Evo Maxtor 3.5 IDE 40GB Hard...

    1 Answer

    Not able to take print on both side in hp 9000 normal series

    You can't print on both sides you miss • Automatic duplex unit for two-sided printing" you're model doesn't have it.
    Read below:

    Shown at left:
    HP LaserJet 9000 series, base unit—
    LaserJet 9000
    base unit =

    • 50 ppm print speed
    • first page out in less than 8 seconds
    • built-in RIP-once technology
    • 300,000 pages-per-month duty cycle
    • 64 MB memory
    • EIO expansion slots

    LaserJet 9000n = base unit +
    HP Jetdirect 610n (EIO) internal print server for Ethernet 10/100Base-TX
    • 100-sheet multipurpose tray

    LaserJet 9000dn = base unit +
    HP Jetdirect 610n (EIO) internal print server for Ethernet 10/100Base-TX
    • 100-sheet multipurpose tray
    • Automatic duplex unit for two-sided printing

    LaserJet 9000hns = base unit +
    HP Jetdirect 610n (EIO) internal print server for Ethernet 10/100Base-TXlj9000hns.jpg
    • Automatic duplex unit for two-sided printing
    • 2000-sheet input tray
    • 3000-sheet stapler/stacker

    Oct 25, 2008 | HP Compaq dc5700 Microtower - Free Flat...

    1 Answer

    610N dissapeared no lights, empty EIO, reset no help

    If you're seeing it intermittently, try the following:

    -remove it completely
    -power cycle the printer with it out
    -check your contacts (be sure no bent pins, etc)
    -Try it in a different slot if you have one (most HP's with an internal jetdirect have 2-3 EIO slots, but since you don't mention what model printer you have I don't know for sure).

    If it's not talking after all that, likely the jetdirect is actually dead. It's been known to happen. I wouldn't waste the money on a replacement, you'll have better luck getting an external card and it'll be cheaper, too.

    HP sells both the JetDirect 170X and 175X externals; there's also the Linksys PSUS4, D-Link DP-300U, TrendNet TE100-P1P, or Netgear PS101NA. Price will vary between $45-80.

    Mar 27, 2007 | HP JetDirect 610N Print Server

    Not finding what you are looking for?
    Linksys by Cisco WAP610N Wireless-N Access Point with Dual-Band Logo

    Related Topics:

    317 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Linksys Computers & Internet Experts

    Prashant M
    Prashant M

    Level 3 Expert

    2260 Answers

    Doctor PC
    Doctor PC

    Level 3 Expert

    7733 Answers

    Les Dickinson
    Les Dickinson

    Level 3 Expert

    18389 Answers

    Are you a Linksys Computer and Internet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides