Question about Gateway FPD2275W LCD Monitor

1 Answer

Screen problem with the hp pavillion zv6000 notebook pc

The screen on my laptop jumps and blinks sometimes and i have to shut it down and restart it and keep pressing f8 and then click on the last known setting that worked well. I have tried everyting to fix this problem by reinstalling the operating system to redownloading the graphics driver from hp, the next step i am about t do is throw this in the trash can. Do you have a solution to this problem

thank you

ellen rexwinkle/ellenrexwinkle@yahoo,com

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,940 Answers

Sometimes intemittant video can be caused by a couple differnet things on a portable system.

1. Bad ground. Some LCD are grounded to the chassis through the hinges. If the screws for the hinges become loose, the ground becomes intermittant. So tighten any screws for the LCD hinges.

2. Sometimes the LCD video cable connection to the video card becomes loose from heat expansion. So see if you can find the service manual on the HP web site, and see how to reseat the video cable (should be listed under the LCD install/removal)

3. If neither of those resolve, then you may have a problem with the LCD itself or the cable that goes to the video card as hte cable goes thru the hinge assembly.

Posted on May 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i turn on my hp pavillion mx50, it shuts itself off after a few seconds and doesnt work. What could be the problem?


The problem is more than likely caused by the flyback transformer, this generates the high voltage to the crt screen, when this part fails the protection circuit activates causing the monitor to shut down.

Jun 03, 2012 | HP Pavilion MX50 15" CRT Monitor

1 Answer

HP Pavillion F1903 monitor flashes on and then screen goes black. I have read countless posts about backlight issues but I cannot see the screen with a bright flashlight. This happened some time ago and I...


Can you check the temp. of your CPU and GPU? If your GPU runs 80 grad C, you have a overheating problem. The problem is a damage to the MB by excessive heat produced by Nvidia GPU. The only way to fix this permanently is to take out the MB and reflow the GPU with heat. You can find a video on youtube how to do it. You must take out the piece of gel between GPU and cooling unit and replace it with copper bar or penny made prior 1983 - still made out of copper. Also clean the fan. Use heat transfer paste like arctic cool - not a glue, on both sides of the penny. Install win7. Win7 does not use the coprocessor and will help to ran the notebook cooler. Install speedFan 4.40 - free utility to see what the temp is of your GPU and CPU. If you did good job it will stay around 55C. If your HP notebook is still running check the temp. If the GPU is running 80C or more it will melt the connections on the MB and quit working sooner or later.

Feb 11, 2010 | HP Pavilion F1903 19" Flat Panel LCD...

1 Answer

HP Pavillion Entertainment computer (laptop)


now u put out to another monitor by cable if u see screen in there ur lcd have problem, if black too it from ur motherboard , checking

Jan 14, 2010 | Computer Monitors

1 Answer

Vertical red line on HP w2207 monitor


Please try to connect the monitor to another PC, if problem still exist then probably there's an internal problem in the circuit board of your monitor wherein an elecronic part/s might be cold soldered / defective. I recommend to bring the monitor to an authorized HP service center to fix the problem. If the monitor display is good if connected to other PC, then your previous PC should be checked if the VGA card (if there is any) is properly placed to its slot & working properly as well as it cables & connections. regards

May 29, 2009 | HP w2207 Monitor

1 Answer

Tower is beeping and monitor on/off switch is blinking


I have not solved the problem of the blinking on off switch, but I have solved the problem of the monitor attached to my laptop waiting so long to start up. I never shut down the computer and I never hibernate it either. I leave it on 24 hours a day.

May 19, 2009 | Acer Computer Monitors

1 Answer

HP vs17e My screen went black for a few moments and when it


Switch off and on your PC and hold down the F5 key and this should bring up your PC in Safe Mode. If this fails, then find a PC repair shop to replace the power supply.

Mar 22, 2009 | Computer Monitors

1 Answer

HP PAVILLION ZE4900 MONITOR goes 'night vision' green


try looking at this link http://answers.yahoo.com/question/index?qid=20080719201319AAgpfTo
basically their saying it's a dying monitor, or magnet... once happened to me with my tv it became green b/c of magnet

Feb 04, 2009 | HP 98785A 16" Monitor

1 Answer

Cursor blinks on my hp pc wen i start sometimes


your harddisk ned to fix error or virus infection.
when u poweer up the computer press F8 key then enter in safe mode.then type "cmd"in run then press enter.then u got cmd prompt.
then type"chkdsk /r" then press enter "y"
then restrt the pc.if your hardisk has error it fix with thisd process.if proble still remains your system is virus infected.scan your system with antivirus.

Dec 29, 2008 | HP vp17 Monitor

1 Answer

Blue screen...sometimes a white screen?


This error is caused by a bad sector or error on the HD. The best course of action to start with would be to either boot up from a windows XP CD or you can try going into safe mode with command prompt. Once you get to a command prompt you will want to type the command chkdsk /r. This will run a scan of the hard drive and repair any issues it is having. If you are booting from an XP CD you will want to choose the options for repair and go to the repair console. For further information please read http://support.microsoft.com/kb/297185

Dec 19, 2008 | Gateway FPD2275W LCD Monitor

1 Answer

Black screen; blinking power light


are using dvi cable did u try to hit the input botton on screen itself thx nick

Feb 07, 2008 | Samsung SyncMaster 204B 20.1" LCD Monitor

Not finding what you are looking for?
Gateway FPD2275W LCD Monitor Logo

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gateway Computer Monitors Experts

olayoju victor

Level 2 Expert

191 Answers

NIK
NIK

Level 2 Expert

206 Answers

David Payne
David Payne

Level 3 Expert

13437 Answers

Are you a Gateway Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...