I keep getting a F-1 read on the digital face with beeping. I do not have a complete owners manual. Help me please to make this stop! Thanks so much! kate

Hi

Error code F5 indicates that there is an issue with the door latch switch assembly; if the switch tests open then the door lock assembly should be replaced. Hope this helps...please post back for further assistance.

Daniel

WHAT IS WRONG WITH YOUR RANGE / STOVE / OVEN?

For a detailed Range/Stove/Oven illustration, click below.

Gas Free Standing
Electric Free Standing
Gas Cooktop
Electric Cooktop
Gas Walloven
Electric Walloven
Warning! To avoid personal injury or even death, always disconnect your appliance from its power source--that is, unplug it or break the connection at the circuit breaker or fuse box--before you do any troubleshooting or repair work on your appliance. Also, because some components may have sharp edges, use caution while working on your appliance.

There's an error code on the digital display

It's stopped completely
It won't bake
It bakes poorly
It won't broil
A burner doesn't work
A burner works only intermittently
I can't adjust the burner temperature
It won't bake or broil
The clock stopped
The temperature is wrong
The oven light doesn't work
There's a self-cleaning problem
The oven door won't close
An indicator light doesn't work correctly
The oven is hot on the outside
I see sparks!
The drip pans need replacing

Hope it may help;

Regards,
VOTIT

Those are error codes which are listed in your owners manual. If you do not have the manual go to the GE web site, customer support section.

Hi,

Before you go working too hard to get you oven to go into the self clean mode(self destruct)....check out this tip...

Self Cleaning Oven Problem


heatman101

" Wish I had read this first. I never would have used the self cleaning option. Thanks for the info!!

Sorry to read about your problem, I hope this helps you out.

you have a defective temp sensor

I tried to help you. Please help me and Rate/Vote on my response, thanks and good luck

I'm having the same problem this morning, saulwizz! Did you solve the problem? Thanks for any leads!

I have a whirlpool stove and when I try to clean it after awhile it starts beeping and comes accross with E1 & F5 the oven when its to clean dosen't seem like its locking. How can I fix this problem. Ive missplaced my book somewhere and can't seem to find it. My timer and clock is digital. Can you help me solve this problem? Thanks!

Means the monitor switch is not operational. This is the microwswitch on the right side of the oven. I'm sure you either fixed it by now or shot it to stop the beeping. Please unplug the oven before taking the cover off.

It was simple. I called GE's toll free help number and they told me what to try and it fixed it immediately!

luvin, F4 is a shorted oven sensor. Under 950 ohms. Should read 1060 ohms at room temp. The sensor is located in the upper left hand corner of the rear oven wall. Remove the 2 screws and it will pull out enough to remove the connector. Catriver.