Dont realy have a problem just ned to know how to set up to my tv

junk it get a flatscreen

computers dont realy have a factory reset the only reset function that exist is with bios to do this when the unit is first turned on press f12 and it will take you into bios but if you dont know what your doing i would not mess with bios but its your computer

best luck

Metric screws either M5 or M6, get them at HD or LOWES for about 35 cents each so you try a lot of different length.
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

Usually a booklet comes along when you buy a remote. If you dont have one go online to the manufacturer website & search for device # you may find a download versions of codes for your remote to use with a variety of components. Or? just buy a new one.

as the switch on the big grey arial been switched to hdtv ? when it should be on tv ? or vicaversa ??
is your tv switched to aux or av channel ??
does the light on the power brick go green when you turn it on ??
check these an come back if it still doesnt work
hope this helps

The normal lifetime for almost all lamps for projectors are 2500-3000 hours in EKO-mode and about 1500-2000 hours in normal-mode

You will notice that the lamp is goint out of time by the light of it, the image will be darker and darker untill the lamp dies/explodes.

If your image isen clear you have to clean your projector, and by that i mean a realy good clean inside it. If you arent sure how to do it i sugest you leave it to a repairshop to do the work, its not expensive and they will do it properly.

Btw, if you ned to buy a new lamp, let me know, i know where you can order a new lamp to realy good price.

Good luck
Nic

It's built into the hazard button on the dash. Buy a new hazard light switch, change that out, and you'll be set.

you can find that in the menu settings and some cams dont have this option...

I dont realy know about this model but in many other model is a 1 oms resistror and is located around the flyback becouse the b+ for vertical output is taken from the flyback secondary voltage if these help you ....good luck and rate me

to connect audio from tv to receiver.Use the monitor out(audio) from tv to receiver .The tv will only put out left/right audio .Also when using the audio out from Sony tv sometimes you cannot use both the internal speakers from tv and audio out from tv to receiver at the same time..Make sure audio is set up on TV menu for audio out..