How to replace trottle cable on YardMachines model 11A-429R729

could not find for your model, similar mtd link shows clearer install video, press the helpful button
Installing Snow Blade onGarden Tractor

MTD 46 inch Dozer blade Installation and Review YardMachines 14 5 HP Lawn...

www.yardmachines.com

should be around 150's check the solenoid on the bottom of the carb make sure its working and opening if ok clean the jets in the carb

Lawn mower blades bolts are reversed thread. Its righty loosen, lefty tighten....

The model shown 11A-034F200 is not a self propel mower. Now if you have a self propel mower, most of the time, the only way is either replace the belt or there may be a spring. I will not be able to tell you further without the proper model number.
Good Day.

The trottle body is located on the intake manifold. There will be a black tube going to it. This tube is the breather tube and on the opposite end is the air filter and it container. You trottle cable and cruise control cable will also be attached to it. If you are unsure of its location, have a friend get inside the car and work the gas peddle. While you are looking at the top of the moter, you should see the linkage at the trottle body moving. Tha linkage is part of the trottle body.

check your gas and oil mix remove the plug take some carb cleaner spray in plug hole pull start replace plug pull start if it fire you mix is wrong.....Good Luck

Thanks for your help, but my friend fixed it today.

I also bought a slightly used yardmachines by MTD without the manuel. I found the manuel for chipper shredder model series 462 thru 465 at the Yardmachines MTD website. I printed off the whole manuel consisting of 14 pages and stapled it together. I now have a manuel. I hope You can find it. Fred

several things can do this but most likely would be
1 TPS trottle postion sensor = replace
2 stuck butterfly valve inside the trottle body = clean out with trottle body cleaner try to get most of the black build up with a old tooth brush
3 bad trottle cable= feel the cable make sure it moves freely if not replace it