Question about GE DBXR463EBWW Electric Dryer

1 Answer

My dryer wont start! I turned the breaker on and off and still it wont come on. The light in the inside wont come on either. Im trying to locate the fuse box to check the fuse ~ HELP!!! :)

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GE Master
  • 8,220 Answers

Your fuse My dryer wont start! - 1e7cb12.jpgLocation: b4f3b60.jpgIn this photo they refer to the fuse as the non-resetable limit.
Want to know how to get in there?
Go here:
How it works: GE dryer

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Posted on Sep 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turned on dryer & tried to start but it gave a load thud noise & wouldn't go. Stop it then re-started a light came on stating clean filter. Clean filter & look inside that area to see if...


there is a sensor located beneath the lint filter, more the likely the dryer sheet residue is on it, gently brush it off, it has two screws. As far as the loud thud noise is/may be a problem with the drum/rollers/glides/belt/idler arm/motor Here is a website that will assist you, once the filter light goes off and the drum will not turn.Good Luck Tim

http://www.partselect.com/dryer+dryer-wont-tumble+repair.htm

http://www.partselect.com/dryer+dryer-wont-tumble+repair.htm

Mar 05, 2011 | LG DLG5988 Gas Dryer

1 Answer

Dryer was running, came down about 40mins later and found it dead. Light wont come on inside. Circuit breaker is NOT tripped.


Try turning the circuit breaker off, and back on again. They sometimes appear to not be tripped when they are. Then we'll go from there if that is not it.

Jan 06, 2010 | Maytag Dryers

1 Answer

Lost power after opening door during cycle.


Try and flip the breaker to off again and push lightly then on , when a breaker trips somtimes just flipping it on it wont catch a latch inside the breaker to actually flip it on.

Oct 29, 2009 | Dryers

2 Answers

The WHIRLPOOL TEDS840PQ0 dryer wont turn on. The


Check the house electrical panel dryer circuit breaker pair--push off, then on. Try the dryer again. If still nothing, measure the voltage across the two slanted slots in the dryer power socket. It should measure: ~230 volts AC. If at or near zero, either one of the breaker pair is defective, or a wire is open from the breaker to the socket. If you read ~230 volts, then the problem is within the dryer--motor runs, but drum doesn't turn (broken belt), or motor doesn't run (bad controller, motor, door switch, start switch. Does the unit get hot? Need more help on your end.

Oct 18, 2009 | Estate TEDS840JQ Electric Dryer

1 Answer

Dryer won't turn on after circuit breaker kicked out and the light bulb inside the dryer shattered.


Im going out on a limb here and say ... the breaker popped - your light exploded ... it will not start. You took a big surge hit and probably smoked the timer.

Unplug the machine - remove the back or the top to gain access to the wiring. With your volt/ohm meter start checking contunity particularly with the timer. The timer is only a switch, you know this right? When you are satisfied with your contunity checks, plug it in and scheck for voltages.

Good luck

Oct 12, 2009 | Whirlpool ET8CHEXSQ Dryer

1 Answer

Has power but won't start. the light inside the


First, go to your circuit panel and turn off then back on the dryer breaker.Second, check for a broken belt. The belt switch will be open if the belt is broken and the dryer will not start. Next.Replace the thermal fuse located on the top right of the heater canister located in the inside rear of the dryer.

Aug 28, 2009 | Hotpoint Dryers

1 Answer

Dryer wont turn on, I reset main breaker but the dryer still will not turn on and run


overheat thermostate is located inside the machine, there may be a serious fault with or short with the heating element,. Good Luck - the Yeti

May 17, 2009 | Dryers

5 Answers

Control pannel wont cut on and dryer wont start


We are having the same problem. We have the Neptune dryer MDE5500AYZ. The control panel doesn't come on. We know it's getting electricity as the light in the dryer is on. Is there a reset button in the dryer?

May 12, 2008 | Maytag Neptune MDE5500AY Electric Dryer

Not finding what you are looking for?
GE DBXR463EBWW Electric Dryer Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Dryers Experts

Dave Harrison

Level 2 Expert

114 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers

vince

Level 3 Expert

1216 Answers

Are you a GE Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...