Question about Hitachi 50UX57B 50" Rear Projection Television

1 Answer

Tint on television stays a greenish color.

My tv. screen turned blue with some static noise. The tv. shut off and I had to unplug the tv. and wait for some time and plug it in for the tv. to come back on. Now the screen has a yellowish or green color to it and I cannot get the picture adjusted properly.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 26 Answers

Tubes are probably dirty. Very expensive fix. Unless it has a warranty or is recently new, look for a local cheap one or one with a smashed screen of the same size. Easy to change the screens out and is very cost effective.

Posted on May 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mits. rear projection tv ws65905 picture has blue color tint


Your blue picture tube is failing. Invest in a new TV. "If" you can find a new set of tubes(you have to replace all 3 red blue and green) they are around $800-1000. Not cost effective. Run the TV into the ground if you want to wait but do not invest any repair money in my opinion.

Jun 01, 2015 | Mitsubishi WS-65905 65" Rear Projection...

1 Answer

My samsung hl61a750a1fxza only has blue and green picture only, why?


Your red tube is dead. There are three primary color tubes that create all the colors. A new tube can cost $250 plus installation and then you will have an old, obsolete TV with one new tube. A new 46 inch TV is less than $400 these days.

May 06, 2012 | Projection Televisions

1 Answer

Green tint


Go to a channel that is in black and white and turn color all the way off.

Screen should be a black and white or gray color.

If green there is a fairly easy way to adjust--let me know what you find and I will tell you how to attempt the adjustments.

Feb 18, 2012 | Hitachi 57S700 57" Rear Projection HDTV

1 Answer

Picture is starting to get greenish, yellowish colored


hitachi model 51f510 projection tv has horizontal lines & has greenish tint,do i need to chang the bulbs??i alredy tryd the magic focus button & manual focus,but unsuccesfl,any ideas????

Nov 27, 2009 | Hitachi 51F510 51" Rear Projection...

1 Answer

Panasonic 56" projection color problems


there are so many technologies for the projection tv's ever one has their own caracteristic faults with out you mention the technoligy used on your tv will be deficult to help you but assuming is a lcd projection you must have a problem with the optical block the repair will be expesive if you do not have a manufactuer warranty for it

Jan 19, 2009 | Panasonic PT-53TW53 53" Rear Projection...

1 Answer

I have a KP-65WV700 and the screen looks a lil to green


OK, I'm the guy that was having the same problem, but had a blue tint to the screen. I also had blue lines running across the screen, and when I followed the steps below that were posted by another user not only did the lines disappear, but the blue haze vanished as well. My tv looks like it's new again, so you may want to try this:

noavatar_s.gif Guest
Rank:nonexpert_s.gif Apprentice
Rating: 0%, 0 votes
I have fixed this several times on my KP 65WV700

As Slinteriors posted if it is a thin curved line you need to adjust the screen control, it's sorta like a brightness for each color, and if one color is too high it will produce a thin curved line.

The best way I have found to get to the controls is by removing the lower grey speaker cover front the front of the TV. There are 6 screws if i remember, 3 on each side. Then it snaps off, seems like its going to break but you have to pop it off pretty good.

Once its loose you have to remove a cardboard like cover plate in the center that will give you access to the small controller board.

Now be very careful while experimenting on which knob controls which colors. Turn them very slow, if you turn to fast you will cause your TV to shut down. If this happens, turn the adjustment back to original spot and turn TV back on and take it slow.

Adjust the correct color until the line just goes away. Its easiest to do this with a black screen.

Nov 18, 2008 | Sony KP-65WV700 65" Rear Projection HDTV

2 Answers

Mitsubishi tv problem


im assumiong you checked the tint in the menu options. if not go check it. other wise it sounds like you have a weak tube, or you do not know how to adjust the screen brightness. this is how i adjust the brightness (you dont need to touch the focus). turn the red up until your whole screen is tinted red, then do the same with the blue and the green. then go through each one and turn down just a little till your pic darkens a little. good luck

Sep 27, 2008 | Mitsubishi WS-65809 65" Rear Projection...

1 Answer

Green lines? Greenish tint to black colors on tv


ohh noooo call a good repair man...
tap on the green crt and check for liquid on the board

Feb 01, 2008 | RCA HD52W59 HDTV Projection Television

1 Answer

Big vertical tinted stripe on screen


Need more information:
Can you isolate which color is causing the banding?
Is there something ON the lense itself?
Is the projection mirror broken or bent?

S

Dec 12, 2007 | Sony Grand WEGA KDP-57XBR2 57" Rear...

Not finding what you are looking for?
Hitachi 50UX57B 50" Rear Projection Television Logo

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...