Question about HP Pavilion DV1010 Notebook

1 Answer

Hot temp I have this old laptop i bought a couple of years ago and lately it started to shut off on me after a couple of mins, the surface gets so hot. Does anyone know how to replace the laptop fan for hp dv1010us? I wasn't sure where to start this process.

Posted by on

  • lil logan May 14, 2008

    Thank you! I may have to try it after I buy a new fan.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 47 Answers

There service manual, which you can download for free from hp's website has directions on how to replace the fan. Here is link to the manual (pg 161):
http://h10032.www1.hp.com/ctg/Manual/c00444244.pdf

Also, I would suggest purchasing one of those laptop cooling fans that set underneath the laptop and plug into the usb. They do a fantastic job of helping to keep the laptop cool and they are not too terribly expensive.

Posted on May 14, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temp on screen rises & flash high temp.


Hallo

The compressor winding's could also be faulty.

regards

May 19, 2016 | Frigidaire Refrigerators

1 Answer

My tablet gets so hot it is starting to have a warp or bend in it .after 10 or 15 min on it it will shut down.its only a year old.what should I do?


Is the cooling fan operating? Are the vents dust free? Are you setting it on a hard flat surface and not on cloth material? Thanks

May 03, 2016 | Barnes & Noble Nook Tablet

1 Answer

I have a 88 chevy celebrity wagon, 2.6. What is happening is when I go to start the car,it will start but then stall right away. If it starts and you can catch the gas quick enough it will run. It is...


First you add octane booster to two year old gas. It is too late for stabil. Find the idle air solenoid and take it out and clean it with throttle body cleaner. Try not to push it in or out. Reinstall and turn on key for I min. and off for 1 min. then start the car.

Dec 02, 2013 | 1988 Chevrolet Celebrity

1 Answer

Coleman evcon furnace


How old is your furnace? Does it have a circuit board that controls everything, or are there separate controls for each function?

Nov 19, 2013 | Heating & Cooling

1 Answer

93 honda accord shuts off after reaching temp


I had the same problem with my accord years ago and it turned out to be that the ignition module would die whenever it got hot and then start working again when it cooled off. It is located inside the distributor and costs a bit less than a whole new distributor. I changed the entire distributor, to be sure all the ignition components were new and would not fail again for a while.

Aug 06, 2012 | 1993 Honda Accord

1 Answer

I have a gas oven whirlpool sf3020ekq2 buners work but oven won't


Sounding like your hot surface ignitor is getting bad. What I would like for you to do is open the oven and take the bottom panel off. This is so you can see the hot surface ignitor. Turn the oven on and look at the hot surface ignitor it is down on the bottom right next to the burner assembly. Does it start to glow and turn cherry red? This ignitor isn't too hard to replace couple of small screws and two wires. Will have to cut the wires so disconnect the unit from the 120 volt plug. Now if it starts to glow and get cherry red hot then the gas valve is sticking and it is the one going bad. That is a little tougher to replace. Turn the gas off at the source and get your wrenches unscrew the gas valve small space so if you want remove the door by just pulling it off the hinges.

If unit is old and you don't like it anyway maybe santa would be good to you and replace the stove oven. The gas valve is about 60 bucks or so and hot surface is about 20 bucks. let me know how it turns out.. ken

Dec 16, 2008 | Whirlpool 30" Self-Cleaning Freestanding...

1 Answer

Adds strait HOT water to a cold cycle.


possible bad cold water valve have had problems with coil connections internally breaking down..on cold setting do you get cold water ? if not valve definitely problem be sure and ck connections and make sure hoses are not reversed also ck screen inside valve at hose connection for trash or sand

Nov 21, 2008 | Whirlpool Duet GHW9150P Front Load Washer

2 Answers

Hot Surface Light stays on


Our success has been to heat the elements to hot for about 5 minutes. Then let cool to reset temp sensor.

Can cause the problem by turning a burner on for a short period of time

Dec 16, 2007 | Whirlpool GJC3034 Electric Cooktop

Not finding what you are looking for?
HP Pavilion DV1010 Notebook Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18386 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Tony

Level 3 Expert

2600 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...