Kyocera CS 3232 copier

my dear you clean mirror and grid wire clean

my dear change grid wire and toner

Just below the main corona unit.
The instructions come with/on the toner cartridge box.

go to www.kyocera.uk side

I beleive you listed your question under the wrong model machine. The CS-4035 is a black and white copier and should not be making bluse dots. Verify the model number please.

no no no pull out the charge unit ***'y out of the copier (green handle) ull see build up of toner on the grid and charge wire, take the grid off and clean everything but dont brake the wire!!!!!! ull need to clean the dev unit edges and the drum so it wont happend again.
Also ull need to clean filters on the back of the copier and 2 filters inside by pass table one big 1 small for wich ull need to take the side cover off 4 screws very important.

Sounds like you may not have the main corona pushed fully home or you cleaned the grid with the grid cleaner that comes with the toner cartridge.When cleaning the grid you must leave the corona unit protruding out of the copier for 30 seconds to allow the grid to dry.Failure to do so can cause arcing in the machine that will give you black copies.reclean the grid and allow to dry before re-inserting

don't even mess with that... I am a certified kyocera tech and I make it a point to throw the thing out...

TO empty the waste toner on a KM/CS 1820 you have to remove one of the side covers from the drum unit on the machine and vac out the old toner i've had customers try to reuse the toner please do not do this. just vac it out good and your normaly good to go!!

3200 is a problem with the exposure lamp. If you are in a dirty enviroment, the problem could be dirty mirrors under the scanner glass.