I have a century bassinet model 10-450 SBQ i took the cover off to wash and i can't get in back on can you help me?

Hi I have the same problem, washed the cover as per directions, and it shrunk and is impossible to fit it back on. There does not seem to be any help areas or a listing for the manufactures site??? Anyone that can give me these details would be very much appreciated, as the baby is due in 3 weeks. Thanks

Welcome to Fixya

Click here to view the instructions to assemble the Bassinet.

Click here to view the manual for your Bassinet.

You will need to carefully place the covers on the frame. Work out the correct orientation.
Then does it get strapped on or is it threaded onto the frame. I am not sure but you may need to slip the wire through the loops in the cover and then insert it into the bottom movement pinion.

You will need to remember a bit, of how you took it off and then work backwards.

Take care!
damnor01

It's easy. Hold the main skirt fabric and drop the pressboard support into the bottom with the feet/nubs down away from the inside. Now the metal frame drops in and next slide the hinged U supports outward. This raises the edges and gives height to the bassinet. The U supports either lock under a plastic clasp on the pressboard or sit into holes on the board. Now button down all the buttons around the interior. Set it back on the frame and snap the bassinet to frame snaps on. Add the hood and baby's new, clean bed is ready for a lullaby. Good luck and if you would like, go to the link below and get a free manual.
Just put in your model number 18270 and a PDF version will be offered. I would save it to your computer for future reference. Choose SAVE or VIEW...but I would save it too.
Kolcraft Instructions Link.

How to put back century bassinett

First turn seat upside down. There should be a slot on each side under the seat, run strap through each slot and turn back over. Pull strap up evenly, put on clasp part on each side, then put chest clasps on, run your straps through back and secure to strap comes between legs.

have a greco bassinet from 2001 model no. 5610nr and lost assembly instructions can you provide?

I need help putting the straps back on a Cosco 5-point car seat. Took it apart to wash and can't get it back together

go to any gm partsdepartmentat the dealership they can give you details on how to take it off bring in vin Please rate my response. Thank you !

First take off the battery cover ( your will need a screw driver). Once you do that take out the batteries and you will see a big screw, unscrew that and take out the screw. You will repeat the same thing on the other side of the bassinet, but you access the screw right on the outside (not like through the battery compartment with the other side). Once both of those screws are removed push back the plastic clip on the inside holder and the bassinet will lift right off. Once the bassinet is off you can take the cover right off. It says to hand wash with cold water and line dry. Hope this helps

www.gracobaby.com/assets/pdfs/instructions/archive/10440-10450-10460_series_bassinets.pdf