Question about GE Profile PSW26P Stainless Steel Side by Side Refrigerator

Open Question

I love my GE profile side by side stainless refrigerator. My only issue is; the panel that is in the water and ice dispenser is not stainless, it is a plastic or some other material. I have no problem with it not being stainless, but this other material has a unsightly stain where our water dripped down. Our water has a high mineral count, so what can I do to get rid of the residual of the water left on? Thanks Debbie

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

the dr
  • 447 Answers

SOURCE: GE Profile Side-by-Side Refrigerator Ice Maker Issue

The Computer on the Door communicates to the Main Control Board on the rear of unit via several small low voltage DC wires .Ive had this problem and is was a bad connection under the freezer door behind the toe plate (it goes through the middle of the hinge). You can try wiggling that connector, but if it still doesnt work you may have to bypass that connector with proper techniques. Unplug before cutting or splicing, If is still doesnt work than There is no other way to tell what the issue is besides replacing display board and Main board. I would try Main board first if connection is good. Hope this helps

Posted on Jan 19, 2008

  • 74 Answers

SOURCE: GE Profile Refrigerator Ice/Water dispenser not working

Check the connector at the bottom of the freezer door first , you should also be able to hear the micro switch click when you press the paddle

Posted on Aug 28, 2008

  • 2 Answers

SOURCE: GE Profile side by side fridge - water dispenser doesn't work

More than likely, your water line is freezing up in the door. You can remove all of the ice cubes and lower the freezer temp to about 3. Leave the freezer door open for about 5 minutes or so and if this does not work, leave the door open a little longer. Also, disconnect the water line at the base of the freezer door, near the floor, and press the dispenser lever. If you have water there, you most likely have a frozen line in the door. Changing the water filter often will help but it is not the answer and is can get quite expensive. By the way, Make sure to hold the dispenser lever forward for at least a couple of minutes each time you test for water flow. If you do not get water at the connector at the base of the door after you have disconnected the line, you have a problem with the valve in the back of the refrigerator.

Posted on Nov 17, 2008

SolutionGuy
  • 331 Answers

SOURCE: GE Profile Refrigerator Ice/Water dispenser not working

Hi Urban Woman,

Unfortunately, your dispenser interface board has gone to appliance parts heaven and needs to be replaced. Fortunately it's relatively cheap. If I recall correctly, all you have to do to access the dispenser board is use a small flat screwdriver. There are 2 locking "tabs"/slots on either side and underneath the board (you will barely be able to see it, they're just that small). 6fb5654.jpg

Of course you already know that you need to unplug the fridge before doing any repairs so I can skip that part.

Insert your screwdriver into those slots and pry the bottom of the board out. Then grasp it with your hands and remove it completely. There are three wire bundles on it, remove them and re-install them on the new board. Then simply snap the new board into place.

This should take maybe 15 minutes to do... super easy job.

SG

p.s. Here's a link to the service manual, but the removal of the dispenser board is not in it (everything else is, though, so it may come in handy later)

p.s.s. Since you're going to be unplugging the fridge for the repair, you ought to go to Home Depot and pick up one of these to plug it back into. Transient voltage spikes are most likely the cause of all your woes... including the main board that was replaced.

Posted on Apr 01, 2009

erpaalai
  • 999 Answers

SOURCE: Ge Profile Stainless Steel Refrigerator panel replacement

You can replace the doors but you will think you bought a new frig when you see what they cost. Most come as an assembly and are very expensive.
Eric

Posted on Jun 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GE Side By Side Ice Machine & Water dispenser not getting water


you may have a pin hole in your water line to your dispenser or you could be leaking at the water valve itself on the water dispenser side. you'll have to pull the refrigerator out from the wall and look where the main water line goes into the back of the refrigerator. you will probably have to take the back off to see. be sure you put the back of the refrigerator back when you are through.

Jun 05, 2010 | GE Profile PSW26P Stainless Steel Side by...

1 Answer

GE Profile side by side with water/ice dispenser. The water is working but the water to make ice is not working, hence no ice. I had ice, used it all and then nothing.


I would try putting water in ice maker if it freezes ice maker is ok if so feplace water valve. careful only 4oz. of water in ice maker

Oct 16, 2009 | GE Profile PSW26P Stainless Steel Side by...

1 Answer

GE profile side-by-side water dispenser works, no ice though


Ice maker bad or the ice maker water valve mounted on the same bracket as the dispenser is bad. These frigs are prone to bad ice makers after a few years.

Sep 29, 2009 | GE Profile PSW26P Stainless Steel Side by...

1 Answer

Ge Monogram built in side by side. Water and Ice


You can do it yourself if you feel comfortable, Here is a service manual for you that should help out. 31 9091 GE Monogram Side By Side Refrigerator pdf

Jun 10, 2017 | GE Profile PSW26P Stainless Steel Side by...

1 Answer

No water, no ice, but new water filter cartridge


If it was running before the filter change you need to purge the filter cartridge of the air in the lines. Also check voltage on the back on the water control valves . While someone presses dispenser you should get 120volts AC on the plug receptacle side for the dispenser . Let me know what you find, Sea Breeze

May 18, 2009 | GE Profile PSW26P Stainless Steel Side by...

1 Answer

Need your opinion on buying a new GE Profile refrigerator.


no dont do it GE is just bad news . if you must by ge make suer you buy the extended warr .and keep it current YOU WILL NEED IT ! ....... what one should buy? it does not matter , there all the same refrig inside ,just just STYLE you pick DONT FORGET EXTENDED SERVICE PLAN !

Jan 12, 2009 | GE Profile PSW26P Stainless Steel Side by...

Not finding what you are looking for?
GE Profile PSW26P Stainless Steel Side by Side Refrigerator Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

KJ4QOB

Level 2 Expert

55 Answers

Da Doc

Level 3 Expert

965 Answers

Jim Akins

Level 2 Expert

82 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...