Question about Kodak EasyShare V1003 Digital Camera

1 Answer

When I turn the camera on the lens only comes out partialy then retracts and the camera shuts off. Yes, I did drop it but there are no visible signs of damage.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Kodak Master
  • 102,366 Answers

Posted on Oct 17, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jackboy
  • 2985 Answers

SOURCE: Dropped Kodak Z740 lens won't open/close

This is not a simple fix
Indeed it may not be fixable
With so many new models coming on line all the time parts are usually available
Kodak Support will advise

Posted on Dec 28, 2007

mcomijohns
  • 477 Answers

SOURCE: Kodak V1003

goto http://www.digitalcamrepair.com/self_diagnosis_page.htm
for self diagnosis.please let me help you before leaving a bad feed back.

Posted on Apr 28, 2008

  • 153 Answers

SOURCE: Dropped camera. lens open and crooked

Sorry to say you have broken the lens, replacement of the lens is the only practical repair and if you cant swap one yourself from a dead camera it would be beyond economical repair.
If you are adventurous you could buy a faulty one of ebay and swap the lens or if the faulty one has a broken screen or mode dial swap yours over to the faulty one..
there are a couple of "tricks" do getting this camera open drop me a line if you decide to proceed...

best of luck

Posted on Jun 01, 2008

  • 1 Answer

SOURCE: KODAK M753 LENSE ERROR 122,1,0,0

I had this problem too, my camera just randomly stopped working and shut off. When I tried to turn it on again it said the whole 'lens error' bit and then shut of. The lens looked a bit crocked so I just gently tried to straighten it out and ta-da! Good as new!

Posted on Nov 03, 2008

  • 52 Answers

SOURCE: The lens wont retract(its stuck) thus the camera will not stay on when power button is pushed

FOLLOW this procidure open the camera then rotate the lens and set it like it was before

Posted on May 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Canon camera turns it self off when I press the start button. the lens comes out & then the camera shuts down. When I restart it the lens retracts 3/4 & then comes right out & shuts down again. the lens...


hi, the camera must also be giving a lens error and must be making a whirring sound when turned on, hold the camera with camera off bang it with flat of hand , a few times , if this does not work , repeat it with camera on, even if this does not, when turning the camera on gently apply pressure on the front of the lens, do this just once , all the above fails , camera has to be service , lens unit may have to be changed

Aug 27, 2016 | Canon Cameras

1 Answer

Lens Error!


In My case, the lens was coming out part way a start up and pulling back in without camera coming on. Some times the screen would stay a dark blue and could not be shut off. Ensure batteries are new or remove and replace existing. Lens will come out part way and retract when the battery door is opoened and closed. Press "on" button and as the lens comes out touch and hold the lens, with a finger placing pressure on the side of the lens. The lens will stay out. With camera upside down blow into the sliding mechanisms of the lens. Grip the furthest most extened lens with two fingers and pull the lens all the way out with steading pressure. The pressure should be equivalent to lifting one to two pounds of bread with two fingers. Perform this with the camera upside down so that any dirt particles can fall out. A slight rocking (side to side motion) of the lens may help. Once fully extended, open and close the battery door. The lens should retract. Turn on the camera. A couple of ideas relatd to this problem 1) If the concentric circles of the lens are not even, this could indicate a large grain of sand. After lens is extended or partialy extended push the lens on the side where the largest gap is while the camera is upside down. This may provide a larger gap for the grain to fall out. 2) Dirty camera case. I turned my camera case upside down over a piece of white paper and was amazed at the particles of sand that fell out. I turned the case inside out and completely brushed and vacuumed the case.

Jul 13, 2009 | Nikon COOLPIX P60 Digital Camera

2 Answers

Lens will not retract, camera was not dropped,


Leave the batteries out for a while and then try turning camera on..hopefully its resets the camera and retracts lens.

Jul 07, 2009 | Kodak EASYSHARE Z1285 Digital Camera

1 Answer

I turn camera on. Lens comes out. beep 3 times. turns off.


Everytime I try to turn it on, the lens comes out for about a second, the camera beeps 3 times, the lens retracts and the camera shuts off. The battery is completely charged and the camera is only 4 months old. HELPP :(

Jun 17, 2009 | Samsung Digimax S500 Digital Camera

3 Answers

Camera Stuck with lens out. Beeps


I dropped the camera on the table a couple of times, twisted the front of it. Suddenly the lens retracted into the camera, the beeping quit, and now I can take pictures again. The Samsung website is horrible.

Jun 03, 2009 | Samsung Digimax S630 Digital Camera

2 Answers

Camera dropped, lens won't retract or expand


Sounds like the lens got bent out of alignment. Call Canon at 1-800-828-4040. They are really good with their support with or without warranty. You can send it in for repair or ask for the Canon loyalty Program. You trade in your broken camera and they'll give you a newer model for an incredible price.

Sep 05, 2008 | Canon PowerShot A560 Digital Camera

1 Answer

Spring visible through the lens


Defective Lens Block.
Needs to be replaced.

Aug 15, 2008 | Pentax Optio 555 Digital Camera

2 Answers

Canon powershot sd30 digital elph


I have same problem. I turn on the camera you hear it trying to come on, shows display pic for like 3 seconds and then shuts down. If I could get the lens to retract I am sure the camera would work.

Jun 23, 2008 | Canon PowerShot SD30 Digital Camera

Not finding what you are looking for?
Kodak EasyShare V1003 Digital Camera Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kodak Cameras Experts

kakima

Level 3 Expert

102366 Answers

Tony

Level 3 Expert

2600 Answers

Greg Cann
Greg Cann

Level 3 Expert

1114 Answers

Are you a Kodak Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...