I have a micro innovation mouse it has 2 parts the mouse has a red light how can i hook it up please

Try unplugging it, restarting and plugging it back in.

or:
unplug it, plug it back in, and restart.

Report back with results.

You won't be able to connect the mouse without the RF receiver. Micro Innovations may sell replacement parts on their website, but odds are it will be cheaper to purchase an alternate mouse. Sorry and I hope this helps.

1.check all batteries.
2. press the connect in the proper sequence. base, mouse , then base, keyboard. (should be listed in the manual) sometimes its base, mouse , keyboard.
3. hook up a old keyboard to boot into windows before you try using the keyboard mouse. (you can run two sets at the same time without an issue)

For the wireless mouse to work with your computer, make sure that it has a bluetooth capability in it. This is how your computer will communicate with your wireless mouse. If it does not have bluetooth, see if your wireless mouse came with a bluetooth dongle. If it does, connect the dongle, download the driver and the pc should detect your wireless mouse.

Let me know if you have any questions.

Hope this helps!

Try to use it on another computer to isolate if the problem is the mouse or the software on your computer.

If the mouse does not work in another computer, then the mouse is defective.

Is the mouse does work in another computer, then reinstall the drivers on your computer.

Go to the manufacturer website to download the appropriate drivers

Thanks

TechSaver

Put it tightly in the USB port then red light willl turn on.

i have a pd905p micro innovations optical travel mouse and it lights up when i plug it into the usb drive but then a bubble pops up and says device not recognized. i have used it before on this computer and it worked fine but one day it started acting up and ever since i have been trying to find away to fix it but i have hit a dead end. can someone please help me?

Normal 0 Turn the mouse over and find the small rest/connect button on the bottom of the mouse and press it. This should connect the mouse to the receiver and work properly. If not, try pressing the receiver button and then press the button on the mouse. This should be done whenever you change batteries or glitch. Hope this helps you. Bud

Normal 0 If the mouse doesn't have a little door to open on the bottom, then try this. Just behind the Left and Right keys where your hand rests, apply firm pressure down on the cover and slide to the rear. Some mouse manufactures have used this type of access to replace the batteries.
Hope this helps. Bud

Normal 0 Try disconnecting the Mouse Receiver from the USB port and reinstall the CD software program. When the program asks you to connect the Mouse Receiver to the USB port, do so and it should work.
Hope this helps. Bud