Question about Computers & Internet

1 Answer

Hcl monitor problem menu displaying buttons not working

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Just replace all of microswitches, all the 4...

Posted on Sep 07, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 198 Answers

SOURCE: monitor problem

Sounds like an inverter problem. If the power supply is internal replace the capacitors coming out of the voltage regulators. These are usually 1000mf and/or 470mf. If that doesn't do the trick look up the numbers on the 8-pin chips that drive the secondary transformers on the inverter to see if they are getting the right voltages.
Good Luck!

Posted on Feb 20, 2008

  • 62 Answers

SOURCE: hcl make monitor hcm780m have problem of displaying monitor basic hardware setting menu

1. change the control panel Micro switchs.

2. cheak the plastic panel

Posted on Nov 08, 2008

Benimur
  • 6966 Answers

SOURCE: monitor display

Hi,

Appreciate the direct "Ask Me"

Unfortunately, an HCL HCM782M monitor is an unknown model. However, on similar instances and occurrence of this problem, it would seem that the controls are damp. Specifically, it would be the internal contacts of the buttons. Pls check if you can dis-assemble, remove the board/control/buttons and perform cleaning. Pls pay particular attention to the rubber pads or the small buttons themselves. if I may ask, any recent continuous rain? If yes, this may have contributed or caused your problem.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

Posted on Nov 16, 2008

Benimur
  • 6966 Answers

SOURCE: display on menu

Hi again,

It would seem that you posted your problem several times. As stated in my proposed solution in your other postings:
Unfortunately, an HCL HCM782M monitor is an unknown model. However, on similar instances and occurrence of this problem, it would seem that the controls are damp. Specifically, it would be the internal contacts of the buttons. Pls check if you can dis-assemble, remove the board/control/buttons and perform cleaning. Pls pay particular attention to the rubber pads or the small buttons themselves. if I may ask, any recent continuous rain? If yes, this may have contributed or caused your problem.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

Posted on Nov 16, 2008

  • 1 Answer

SOURCE: HCL Monitor Screen Display Problem with Contrast menu showing up.

my hcl 17inches monitor is displaying contrast,brightness etc automatically
in the middle of the screen.even if i press the menu buttons it
disappears for a sec and comes again and again.what should i do to
solve this?

Posted on Nov 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

HCL Monitor Screen Display Problem with Contrast menu showing up.


my hcl 17inches monitor is displaying contrast,brightness etc automatically
in the middle of the screen.even if i press the menu buttons it
disappears for a sec and comes again and again.what should i do to
solve this?

Sep 13, 2009 | Computers & Internet

3 Answers

Contrast Ghost


This is common problem observed in many monitors compaq,HP,HCL,IBM this is happens mainly in rainy season due to moisture,by this moisture monitor button circuit get rust inside and button pad remain pressed. so it shows a strip at the middle of monitor like contrast or brightness. So this is minor problem just replace the monitor display control button sensor or circuit.Temporarily you can warm up the monitor by hanging a bulb of 60 watt nearer your monitor to takeoff the moisture.(Dont hang the bulb too near to the monitor). It definitely solves your problem.

Good Luck

Sep 02, 2009 | Computers & Internet

1 Answer

Monitor problem


Not a solution but I am having the same problem. Besides this time, it says on my screen, and half of my screen is outlined by a blue box and it a bit darker than the other half. My Monitor buttons do not work either ... (Besides the turn on/off)

Feb 24, 2009 | Computers & Internet

4 Answers

HCL HCM780M CIRCUIT DIAGRAM


SIR..., regarding monitor...display block characteristics which is operated manually by buttons situated bottom of monitor is anytime coming at the centre of monitor display... The settings block comes on suddenly and we are unable to exit from the same sometimes the block goes off without any action and everything is fine till it is back again and it is come again and again.....by all this i did'nt work on my PC...all result it's useles......please sir giving your suggestion as soon as possible....... This has been happening for the last 1 year and is a real pain Please send some solution

Jan 23, 2009 | Computers & Internet

5 Answers

Hcl lcd monitor osd locked


my moniter was automatic restarted, and osd lock not open,where is is osd open option?

Dec 19, 2008 | Acer AL1916W 19" LCD Monitor

1 Answer

Monitor display


Hi,

Appreciate the direct "Ask Me"

Unfortunately, an HCL HCM782M monitor is an unknown model. However, on similar instances and occurrence of this problem, it would seem that the controls are damp. Specifically, it would be the internal contacts of the buttons. Pls check if you can dis-assemble, remove the board/control/buttons and perform cleaning. Pls pay particular attention to the rubber pads or the small buttons themselves. if I may ask, any recent continuous rain? If yes, this may have contributed or caused your problem.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

Nov 16, 2008 | Computers & Internet

2 Answers

Display on menu


Hi again,

It would seem that you posted your problem several times. As stated in my proposed solution in your other postings:
Unfortunately, an HCL HCM782M monitor is an unknown model. However, on similar instances and occurrence of this problem, it would seem that the controls are damp. Specifically, it would be the internal contacts of the buttons. Pls check if you can dis-assemble, remove the board/control/buttons and perform cleaning. Pls pay particular attention to the rubber pads or the small buttons themselves. if I may ask, any recent continuous rain? If yes, this may have contributed or caused your problem.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

Nov 16, 2008 | Computers & Internet

2 Answers

Monitor display problem


It seems that your menu switch is short. If you can open up the Monitor check out the connection of your switch and the related components, clean with Spirit or alchohol, check out the switches, if found faultty replace it. That should solve the problem. Good luck.

Dec 05, 2007 | Relisys TL 700A (White) 17" LCD Monitor

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

304 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

kakima

Level 3 Expert

102366 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...