I have aquired a HP officejet 4255 all in one without a manual and not being experienced with this technology i would like to have the section of the manual which gives the instructions to replace the cartridges.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1) With the power on, disconnect the USB cable 2) Follow the recommended procedure in your manual to remove the ink cartridges 3) Wait for the "Insert cartridges" message 4) Unplug the machine for 1 minute 5) Reconnect the power cord (press power button if necessary) to power on the unit 6) Reinstall the cartridges, close any access doors 7) Allow the machine to print a calibration page (if necessary) 8) Reconnect the USB cable Try printing again.
If this procedure fails, your OfficeJet may need servicing by a qualified tech.
The default setting for an Officejet 4255 is to answer the phone after 2 rings. You can change this setting to a higher number of rings which will give you time to answer the phone before the fax picks up.
The instructions you need to change the default answer setting can be found on page 47 of the user manual.
Without turning off the product, disconnect the USB cable from the rear of the product.
The USB cable connects to the port on the back of the product. The port is labeled with the USB icon ( ).
Figure 1: Example USB connection (your product might not look exactly the same as this example)
Remove the cartridges from the product.
Wait for the ' Insert Cartridges ' message to display on the control panel.
Disconnect the power cord from the back of the product.
Wait 60 seconds.
Reconnect the power cord. If the product does not automatically turn on, press the Power button ( ).
Reinsert the cartridges, and then close any open doors on the product.
If you receive a prompt to print a calibration page, do so.
Reconnect the USB cable to the rear of the product, and then try printing again.
Solution two: Service the product
If you have completed all the steps listed above and are still experiencing a problem, service the product.