Question about Fujitronic FA-1300 Air Conditioner

1 Answer

Fan comes on but sounds like something is trying to start but does'nt.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Expert
  • 3,773 Answers

Do this:
Check inside and outside coils for cleaning with coil cleaner spray
purchase a hard start kit compressor relay from Appliance parts store (instructions to install are on the pkg)(easy job)
Check capacitor(remove and take to appliance parts dealer. They will checkit)(easy job)
If this was helpful please rate me.
Leo Ponder Appliance-Tyler,Texas
imufo2@sbcglobal.net

Posted on Sep 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power controll card a 2290 240008


try cleaning the condenser section, under the unit there is a fan that may be dirty or hitting something, clean it out.

Apr 21, 2014 | Whirlpool Mastermind

1 Answer

Minimax NT.. Shows green power light on control panel, but will not start up when turned on remotely. If i turn the main power switch on the unit off the on the fan comes on for about 15 seconds then...


I would call the Pentair technical support line because they may be able to help you figure this thing out. I hope this helps.

Please vote on this answer. Thank You.

Aug 24, 2011 | Pentair Minimax NT Heater

1 Answer

My desktop won't start the power box spin the motherboard light is on the fan comes on everything is in their place


Please try to cleanup your memory cards, and if this does'nt work, try to replace it. Have a nice day.

Aug 16, 2011 | Computers & Internet

1 Answer

Laptop recently started to make noise on start up, feels and sounds like it's coming from the area below the keyboard in the lower left part, it's an acer aspire 5570-2067. it makes noise for a while, then...


Def sounds like the fan , from where you say the sound is coming from . normally the fan should be able to be cleaned the panned holding the fan in the left hand corner . clean the fan with compressed air , or a paint brush . if this fails then you need a new fan .

Nov 23, 2010 | Acer Aspire One PC Notebook

1 Answer

When does the humidifier fan start? Does the water flow trigger it? Will the fan nt start if I turn off the water supply?


Humidifier should be powered from the furnace heating 24 volt terminals through a humidistat and then to your humidifier. The fan and the water solenoid on the unit should come on together. if the water is not turned on the fan should still run, unless the unit is not plugged in.

Nov 13, 2010 | Aprilaire 700 Humidifier

2 Answers

E04 comes on after fan purge cycle-Pentair minimax nt pool heater


This is a fan falure code. It can mean the fan has problems (not likley if the fan goes and isn't labored) You have a sensor in your exaust (probally not this if you don't get a good start) The culperet is probally in the negetive pressure sensor. This is a 2-3 inch disc with wires going to the controls and a rubber tube going to the fan. Pull the tube from the fan and make sure the fan fitting is clear (poke with a tooth pic) Be sure their are no kinks in the hose. If the heater is 4 years old the diaprahm could be bad in the pressure sensor. Check the other things first but this is probally your problem. Good luck, hope this helped.

Jan 26, 2010 | Pentair Minimax NT Heater

1 Answer

Flame wont stay lit


Sounds like a flame sensor problem. The board is not getting the proper signal from the flame sensor so it thinks the burner did not light and shuts the gas supply off. It keeps the blower operating to ensure that no gas is accumulated in the burner area. I suggest you contact a local mechanical contractor to service your heater.

Jun 23, 2009 | Pentair Minimax NT Heater

1 Answer

Pentair Minimax NT 400 heater. fan keeps coming


Sounds like the controller is the problem. This is the circuit board that has the display and controls on it. You can swing that panel open and try tapping on the white plastic cover the controller is under that. This might get the fan relay to release but you will have to replace the controller it will stick again

Jun 06, 2009 | Pentair Minimax NT Heater

1 Answer

Thru the wall ac unit


Sounds like the fan shroud on the hot side has come loose, or something is rattling around inside. Looking through the exterior vents may reveal the trouble, but the unit will have to come out & have the cover removed for repair. You can try lifting the outside corners one at a time while the unit is running & see if the noise stops. If so, a shim wedged under that corner will hold you for the season.

Jun 25, 2007 | Whirlpool ACQ158XP Wall/Window Air...

Not finding what you are looking for?
Fujitronic FA-1300 Air Conditioner Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fujitronic Heating & Cooling Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Bill Long

Level 3 Expert

587 Answers

Jay Finke
Jay Finke

Level 3 Expert

1338 Answers

Are you a Fujitronic Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...