My m3 player says rebuilding and it won't stop saying that I don't know what to do. (it's said rebuilding for a couple of days)

I`m guessing you mean rebuild caliper. it is probably cheaper to buy a rebuilt one then rebuild,, if you don`t have experience you won`t know it the caliper condition is good enough to rebuild then if you damage the new seals while putting it together then you have to buy another kit and a piston if its bad.

Vanessa,give Lincoln/Mercury/Ford a call and run this by THEIR Service Manager. they are usually helpful
on the phone. Let us know what they say,please?(:^) don-ohio

Hello
Just get into the Wharfedale site and upgrade it with latest software available, that suit to your DVD-M3. It will take some time, say about an Hour to complete the donload and installation. Don't stop as download stops, the softwre must be installed, and it will happen only after the full download. After sucessfull download, the set will propt you that has done sucessfully. Till then, never switch off the net connection, or do nothing at set end. If installation is not successful, the fault you describe here will occur. OK.

No transaxles make 100,000 miles

What your saying, including the rebuild
is common

Asian transaxles & all Van type vehicles,
are something you don't want to own

I used to own a trans shop,so I will leave
you with that

Can't fix slipping,drive a couple of days,
& your pulling the trans out again

You can get the parts to rebuild your steering gear, but in all honesty for the trouble and time you will have invested in rebuilding the thing. If it were me (and beleave me when I say there was a time I wanted to do it all myself. up to and including manufacturing new parts from a chunk of steel) I'd go with a rebuilt steering gear. You can try to replace the seal but in the long run some thing made it give out in the first place.

I faced a similar problem with Mine a couple of days ago.
Try these below
1. Keep the unit plugged to the wall socket (and charge). Green light (indicating charging) may not glow. It doesnt matter. Keep it on for a few hours.
2. Then try to turn on the unit.
3. If it still doesnt turn on, fold the unit and keep it aside for a few mins (say 10 mins).
4. Open it and then try to turn it on.

Mine worked with step 4.

See if this helps.
regards,
Lakshmi

don´t you by mistake activate the progresive scan function

have you change the plugs

check new USB cable or resolder the USB connector

also change the usb plug istelf.

you need to convert that to .avm format