Question about Bosch Axxis WTA 3510 Electric Dryer

1 Answer

Hello On my Axxis I lost the little flap (rectangular peace on te lower left side of the dryer. WHere can I get that?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 101 Answers

Try to google it, you may found it ..

Posted on May 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Maytag Legacy series dryer making loud noise. Sounds like something flapping.


A common problem on these dryers is the blower wheel itself will wobble out and make noises. Pop the top with a putty knife then remove the front panel. Check the blower housing for looseness.or something in it. I worked on a monkey wards dryer with a bad blower wheel and made crappy movie on my phone:

Sep 04, 2012 | Maytag Dryers

1 Answer

My Bosch Axxis 5410 dryer won't start. The time lights up and the status light says drying, but the dryer doesn't start. There's a little dot on the lower right hand of the time remaining which hadn't...


This type of diagnosis will require accessing the internal components & making voltage & resistance checks with a volt/ohm meter. There are several different components that could cause this symptom & yes it is possible that the door switch is bad. This model of dryer should only be worked on by an experienced, trained technician due to all of the electronic controlled parts. richroth_121.jpg

Mar 20, 2011 | Bosch Axxis WTL 5410 Electric Dryer

1 Answer

Cant find the model number on Bosch Axxis dryer to order new dryer vent


Hello,

Welcome to FixYa.

I`m not sure what locations you`ve already tried, but typically it will be on a tag on the inside of the door.

If not there you should be able to revert to the back of the unit and there will be a white tag with a bar code and also model and serial number.

Let me know how you make out or, if you`ve already exhausted those typical locations you can try along either side of the unit.

I`ll watch for your reply. Good luck.

macmarkus :)

Aug 03, 2010 | Bosch Axxis WTL 5410 Electric Dryer

1 Answer

How do I change the electric bulb inside ????


First of all, unplug your dryer from the plug. Then open up the door, and look directly to the back of the drum and you should see a rectangular cover with a phillips head screw. Unscrew, remove the cover, and then unscrew the bulb. Make sure you replace it with the same bulb. Usually, they're 10w appliance bulbs. I hope this works for you, but if not - feel free to contact me again. Good Luck!

Jan 13, 2010 | Bosch Axxis WTL 5410 Electric Dryer

1 Answer

I dont know how to change te bolb


Open the door to the dryer. Look directly in the back of the dryer, and you should see a rectangular cover with a phillips head screw. Before you begin, first unplug the cord from the wall. Then, unscrew the cover and remove it. Unscrew the bulb, and then replace it with the new bulb. It should be a 10 watt appliance bulb. But double check the old one, before you buy the new one. If there's no info. on the old one, then get the 10 watt bulb. If this works for you, great! If not, feel free to contact me back. Good Luck!

Jan 05, 2010 | Bosch Axxis WTL 5410 Electric Dryer

1 Answer

Dyer will not turn on. I have cleaned the heat sensors, the lights go on, it is not over loaded..any thoughts


check the angle on the vent hose on the back of the machine and the vent flap hoodie thing outside also the vent hose should not exceed 11 feet. I had this problem and replaced the springy plastic covered vent hose with a rigid aluminum one and still have to check from time to time to make shore the hose is clear where it attaches to the machine. The lint from the extreme spin on the axxis washer is very fine and slightly damp it binds like paper mache.

Sep 29, 2009 | Bosch Axxis WTA 3510 Electric Dryer

1 Answer

Blows cold air and produces little lint in the vent


To get a rear control LG dryer apart: Open door and remove two phillips head screws at the 5 and 7 o'clock positions. Use a putty knife to release the clips holding the top panel to the dryer front by pushing the clips in at the seam of the dryer top and front, a couple inches in from each side. Swing top back. Remove two phillips head screws at the top, allowing front panel to pull forward. Unplug drum light and door switch and drum sensor plugs, allowing front panel to be completely removed and set aside. Now, look at the burner area at the lower right. Behind the gas valve you will find a small (about dime sized) high limit thermostat on the left side of the burner cone. It has two wires attached and has a small pin in the center of it. (Only on gas models) Push the pin in.
Now, if that get's you ignition again, CORRECT VENTING ! Get rid of flexible vent material. (use only rigid aluminum vent pipe and elbows) Clean out vent pipes and outside vent hood. Outside vent hood should be the kind with a four inch flap for the opening, not a two inch flap. Tripping of the high limit thermo is almost always caused by inadequate air flow.

Dec 28, 2008 | LG DLE5977 Electric Dryer

1 Answer

Drum doesnt turn... motor fine.


From your description I would suspect a broken belt although I am unfamiliar with your model. Once the belt [which transfers drive from the motor to the drum] breaks, it would'nt matter how well the motor runs, it can't turn the drum.
Hope this helps!

Oct 08, 2008 | Bosch Axxis WTA 4107 Electric Dryer

1 Answer

How to clean the bottom filter


Don't know how old your machine is but on my wtl5400 the bottom flap is opened by:
1. open the drier door
2. note small round button on the lower right hand side of the drum surround
3. press the button which will spring forward then
4. lower filter cover springs off giving acess to filter drawer
NB if the filter is over full the button will spring open itself as a gentle hint
NNB YOU CANNOT CLOSE DOOR WHILE THE BUTTON IS EXTENDED so take care door will only close when lower cover has been correctly replaced relocating the button flush with the front of the machine

Aug 28, 2008 | Bosch Axxis WTL 5400 Dryer

1 Answer

Kenmore Electric dryer not heating drum


Check your vent line if it is stoped up you have no air flow bent ocrushed check the flap is not stuck

Dec 12, 2007 | Bosch Axxis WTL 5410 Electric Dryer

Not finding what you are looking for?
Bosch Axxis WTA 3510 Electric Dryer Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Dryers Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

MightyMikeJr

Level 3 Expert

347 Answers

noel
noel

Level 3 Expert

3396 Answers

Are you a Bosch Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...