Question about Crosman Optics
I just finished replacing mine it was easy. Use a small screwdriver in the slot and tap it in a circular motion until it loosen then it will come out easily. Go to the hardware store and buy a blue .5" maybe it's 17/32" X .125" thick. remove the old washer, the puncture pin, and the screen. Clean all of the parts with alcohol. Reassemble in reverse order and tighten the brass locking "screw" securely. It's a bit of work screwing it back in so be carefull not to round off either of the slots. I used a standard 1/4" and .125" screwdriver like it was a lever to spin it around. The smaller screwdriver at first the the lager one to get it tight. It may take pliers to tighten the new cartridge in mine did. Instead of doing it as I did and tighten the H__l out of it tighten and test in small incraments. Testing after each one. This does work and the seal are readily available in the plumbing section of good hardware stores. Happy Hunting
Posted on Jan 21, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Probably not by you, but by the shop, maybe. It sounds like the needle was bent and lost it's seal. Crosman has repair stations, if they don't fix it, they will send you another one. I have sent them guns before and got brand new ones instead of the old piece of junk I sent them for repair. They also bought out Sheridan/ Benjamin line of Air rifles, And they repair all those too. I sent them an ancient rifle, an old Benjamin Franklin,17 cal. bare bones stock and barrel only, they sent me back a total refurbish, welded, painted, new .22 cal.barrel, all new guts, unbelievable. I think the total cost was $35 on that one. They wanted $15 for paint, I told them I didn't want it painted, they said, OK, Get a hold of them. Hope this helps.
Posted on Jul 03, 2010
Tips for a great answer:
506 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: