Question about Vizio L37 Television

4 Answers

Tv will not come on at all, it started out clicking several times when you would turn it on, it took several trys before tv would come on, now it does nothing, only 2 yrs old

Posted by on

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Vizio Master
  • 8,457 Answers

Most common for these problems are the power supply board is dead.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbush power supply board for the replacement.

Posted on Sep 01, 2010

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

It's actually the sub power board on those that goes bad it's a small box above power supply hold a hair dryer on it it will work for a bit after the transformer becomes hot.hold hair dryer above the yellow transformer unplug tv hold power button 1 min with tv unplugged plug in and try if it works it's the sub power supply transformer. As soon as it cools it will turn off and won't come back on again until you reheat with hairdryer.
tv will not come on - 11_28_2016_1_55_12_pm.jpeg

Posted on Nov 28, 2016

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,361 Answers

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

Failed TV and Monitors: http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague

Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.

Posted on Sep 01, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Bad videoswhen warm up

Posted on Oct 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my tv sounds like it start but it wont como on i change the power board but still did the same what could it be thanks


Samsung 52" TV Repair - Won't turn on Clicking Sound ...

? 9:37
https://www.youtube.com/watch?v=2WpSJy_kANs
Apr 13, 2012 - Uploaded by Kathy Burton
It makes a clicking sound several times before it turns on, seems to ... Samsung 52" TV Repair - Won't turn on Clicking Sound ...Maybe it took a little longer than that, but I was happy. ... My TVworks like new. ... Samsung No Start / Clicking Repair - 52" LCD HDTV - Duration: 8:26. by clipdan 169,453 views.

TV Will Not Turn On - Troubleshooting Help for Finding ...

? 2:32
https://www.youtube.com/watch?v=kEDVc-BXf0I
May 1, 2014 - Uploaded by ShopJimmy.com
TV Repair Help for a TV that Will Not Turn On - Troubleshooting Tips for finding symptoms and ... hi my tv flashes red and bluebut wont turn on.

Dec 12, 2015 | Televison & Video

1 Answer

Samsung dlp dnie


just from personal exp the easiest thing to do may fix or at least make it better. if u see puffed and leaky caps on power supply replace capacitors. if really dusty clean. both previously mentioned and both helped me. my tv was completely dead and replacing caps got it to power back up and work. it takes two trys to come on but works great so far. then i cleaned every nook and cranny with a small vacuum hose and different size/angle brushes that could be attached to hose. i only took out the psb board with caps and didnt touch anything in there that i could mess up. just cleaning helped enhance the colors. right now this is the best picture ive had on a tv and it was completly dead when i got it.

Jul 28, 2014 | Samsung HL Televison & Video

1 Answer

I have a 1997 Toyota Avalon. Sometimes just makes a clicking noise when trying to crank it. Sometimes it trys to turn over then stops and makes the clicking noise again. Usually starts if you keep trying....


Have the starter or solenoid checked. It's possible to get second hand parts from a Salvage/Breakers yard. If you don't mind getting dirty and can use basic hand tool. You may want to invest in a Repair Manual: http://www.amazon.com/gp/product/156392336X/ref=as_li_ss_tl?ie=UTF8&tag=toyota0d-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=156392336X It can be very useful for a DIY'er .

May 10, 2013 | Cars & Trucks

1 Answer

RCA L32WD12 will not turn on without several trys


Likely bad filter caps in the power supply---if you look inside and find this it may be a easy repair.


12_18_2012_8_17_56_pm.jpg12_18_2012_8_18_17_pm.jpg

Dec 18, 2012 | RCA L32WD12 32 in. LCD HDTV

1 Answer

My tv trys to turn on several times but will not, I checked the trouble code tells me its the lamp . I took the back cover off I can see the lamp starts to come on but it shuts down and trys to restart...


Tv "LAMP" LED light is flashes or stay lite?The tv Projection lamp been in ur tv like 1 1/2 or 2 and tv been on and uses it like 4 or 5 hours daily?Yes tv projection lamp is dead and also might the board that call the Ballast board it dead too.This Ballast board,that board job is to help to ignite the tv projection lamp.

Jan 31, 2011 | Toshiba 52HM95 52" HDTV Projection...

1 Answer

I am trying to program it for my Zenith


Please log onto www.Dynatron.com , enter your model number, then click on 'Codes". There you will see codes for all television models...find Zenith, jot down the codes given. You will see several. Write them all down seeing you won't know yet which one to use. Then click on "Programming A Remote". You will see both manuel and automatic search selections. Print these (or write down) and keep...You WILL need them in front of you for the programming to take place. Keep in mind...programming a TV sometimes takes several trys (AND sometimes several trys using different codes, of course ONLY one code WILL be the working code.) Take your time, understand what you are reading to ensure you have understood the steps you MUST take in the timely manner you have in which to complete. In short...know the steps, see the codes(DO one at a time), and press the selected buttons in a quickset timetable to ensure you have captured and programmed the code for YOUR television. If you should encounter any other problems related to your rwemote, please refer to the "TROUBLESHOOTING" guide on the Dynatron website. Good Luck!

Jan 28, 2011 | Dynatron MR140 Remote Control

1 Answer

My Sony KDS-60A2000 is 41/2 years old. About 2 weeks ago I could not get the tv to power up. the green stand by light just kept blinking. I powered off, then powered up again and the tv started and and...


Hi,
TV needs lamp replacement as existing lamp got weak or has been reached to end of its working life, please note that lamp is not dead or broken so that is why lamp lit is not lit at tv front.
Hope these info will help you.
Thanks.

Nov 03, 2010 | Sony KDS-60A2000 60" HDTV

1 Answer

Press on button but it clicks a dozen times before it turns on


If green and or red lights are flashing while the TV trys to start the lamp is burnt out, time to replace.

Apr 29, 2010 | Toshiba 52HM95 52" HDTV Projection...

1 Answer

RCA SCENIUM trys to start up but wont start


I kind of had the same problem..I had audio..no picture..and the display would flash 5 times. Per the manual it said the lamp needed replaced. After reading a post by someone that had the same problem and replaced the lamp, it still didnt fix the problem..I took my set in to the repair shop. Turned out to be the light engine..$1000.00 for the part...$250.00 for labor! The tv was only 15 months old..and not even used on a regualr basis..I maybe had 300 hrs on it. I did not buy the extended warranty (will for my next tv!!!) but after many heated conversations with RCA..they agreed to pay for the part..I got stuck with the labor, atleast that was better than the whole bill. Anyway..starting to act up again..after only 5 months..bottom line..I'll never buy an RCA again!!

Oct 29, 2007 | RCA Scenium HDLP61W151 61 in. HD-Ready...

Not finding what you are looking for?
Vizio L37 Television Logo

805 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vizio Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74136 Answers

CoppellTVRepair.com

Level 3 Expert

749 Answers

Computer Repairing
Computer Repairing

Level 3 Expert

14641 Answers

Are you a Vizio Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...