My washer will not spin on the regular cycle, but it spins on delicate cycle. We already cleaned the pump.

how is the spin in the delicate cycle compared to the reg cycle?

Hi,

Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


heatman101

=- =- =0

somethinmg is in the pump

check drain hose kink or belt adjustment...worn clutch...basket drive

is it IE or LE please confirm it. if it is LE code the fixing procedure is given below This usually happens if you're washing on a delicate setting with a moderate load of clothes. Apparently, delicate also means very few items to wash. To clear the LE code - no need to unload the clothes:
1. Press the power button to turn the washer off.
2. Press the power button to turn the washer back on.
3. Cycle the spin cycle selection to 'no spin'.
4. Press start.
The washer should set to one minute, lock the doors, then drain out the excess water.
Once the 'End' cycle comes up, unplug the machine for several minutes.
Plug the washer back in, press the power button, then set the washer to 'normal' with 'low' spin setting.
Note that the only difference between the normal setting and delicate is the wash time and spin cycle speed. If you have a moderate to large load of delicates, use the normal setting on low spin cycle. The clothes really don't care. Also, make sure you're using 'HE' detergent - low suds. Regular degergent in a front load is not recommended.

what's the brand name and model number,all washers are different,most likely it's the motor humming or the pump is humming,could have something stuck in pump,if the water doesn't drain the washer won't spin,if you have a shop vac pull the drain hose out of stand pipe or sink,stick the shop vac hose onto the drain hose,get it down as low as you can and suck out the water and then see if it spins,if there's alot of water in the tub suck it out of the tub first then go to the drain hose,if it spins when water is out you know it's the pump but if you say water is still in tub i would have to say it is the pump,

broken lid switch



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Thanks for your question You say it works on one cycle but not the other lets sat you start a regular wash ,the washer should fill ,wash for the minutes you have set, pump out the water #spin , Stop fills & rinse stop pump out water &spin If you try a delicate cycle and it does not do what it did on regular cycle . You have a timer problem . Thanks for your question hope i helped you solve it . THE APPLIANCE DOC

Dear friend,
ngfam at you service!

You have an electronic problem and have no choice but to call service!

If the washer is 10 years or older its not worth investing money to fix it! The new ones are mush more efficient and clean better!

Either way this is a service problem to remedy!
Below I gave you a nation wide service thats very good!

We sell appliances for 65 years and I recommend this nation wide Factory repair service!

Call A&E Factory Service /They service nation wide -USA
And are available 24/7 for making appointments!

If the appliance is 10 years old or more,it may make sense not to invest any money to fix it!

Happy to assist you,
PS. PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF!

Replace it