Question about Dishwashers

Open Question

Hi i have a smeg df 410 sdx 450 wide dishwasher that is coming up to three years old ,the fault it has developed is that it wont switch on ,press the button and nothing happens,no lights or the normal beep.240v is getting to the button and when the button is pushed on 240v comes out the other side and goes to the various pcb's but the appliance wont do any thing,can you please give me some ideas.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Whirlpool GU2548 green light flashing, nothing working

hold the start button down for bout30 secs this clears the programme...hopefully

Posted on Jun 27, 2007

Ad
  • 1314 Answers

SOURCE: Diswasher stopped working

there is a fuse in the washer that needs to be replaced reply to me and will walk you through it

Posted on Jan 01, 2008

IFIXALL
  • 868 Answers

SOURCE: New World DW60 dishwasher not

I f you have warranty on this please call them, you have a defective D/W.Unless there is no charge for repairs ,don't spend a dollar on what is going to be a on going problem ahead.To explain how to fix this is what the manufacturer should have done in the factory and not made 1 dollar off of this defective D/W until it proved this to be ready .What has happened to Quality Control ? Does it no longer matter ? Very sorry ,you should seek a refund ASAP.

Posted on Jun 23, 2008

  • 1 Answer

SOURCE: Smeg dishwasher L5 eco when

brought a new dishwasher

Posted on Aug 31, 2008

  • 42 Answers

SOURCE: No electricity

I would check to ensure you have power to the dishwasher and that the door is closing/secure properly.

(i.e, Plugged-in properly under sink/back or washer, check for tripped circuit-breaker, and door latch is grabbing properly)




Posted on Jan 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My smeg Module DF 612 SDX7 dishwasher tripped the circuit last night early into its cycle. We could smell burning coming from the dishwasher. Any ideas and what we can do to fix it?


If you can get it to operate for a few seconds, that will at least tell whether the motor is still good and turns freely. Otherwise it sounds like board may have failed.

Good luck!

Jun 21, 2015 | Smeg Dishwashers

1 Answer

Smeg D1 612 CA dishwasher wont run


You may have to give a little more information.
Have a look at the manual, here -
http://www.manualslib.com/manual/343502/Smeg-Di612ca.html
and check for error codes/lights etc (p17; faults E1-E9)
Hope this helps

Oct 28, 2013 | Smeg Dishwashers

1 Answer

Dishwasher cavitates. I have a Smeg DI612CA9


Does the drain hose loop up to the top of the unit before going to the sink drain? If it goes down first it may be siphoning or draining by gravity.

Aug 08, 2013 | Smeg Dishwashers

2 Answers

I desperately need a 400 mm wide dishwasher - is there any out there?


NO i dont believe so the 2 width of the dishwashers made are

18 inches...450 mm

24 inches..600mm

a 16 inch...400 mm is not one know to be made

Aug 28, 2011 | Dishwashers

1 Answer

My Smeg dishwasher model DW1 410 is not drawing the water any more.


More than likely water inlet valve is bad. Maybe replaceable.

Nov 04, 2009 | Smeg CSU2001 Built-in Dishwasher

1 Answer

Spray arms don't spin on Smeg DWF 410 ss


Remove he wash arms and visually check for obstructions in the holes where water sprays out if any number of these are blocked it will happer the turning of the arms

Jan 21, 2009 | Smeg 18 in. DWF410SS Slim-Line...

1 Answer

SMEG DWI410 TRIPS CIRCUIT LATE IN WASHING CYCLE


just possibly
take the kick panel off. On some smeg, there is a small suppressor capacitor on the lhs tucked in the wiring. this breaks down. snip it off - no need to replace

Jul 18, 2008 | Smeg 18 in. DWI410 Built-in Dishwasher

2 Answers

Smeg dishwasher


Hi, You can download SMEG dishwasher manuals from here: http://www.smegtech.com/site/smeg/myapp/libretti/index.php?lang=EN Al.

Feb 02, 2007 | Smeg CSU2001 Built-in Dishwasher

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Owen Barnes

Level 3 Expert

867 Answers

Brad Brown

Level 3 Expert

15729 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...