Question about Sony KP-51WS520 51" Rear Projection HDTV-Ready Television

1 Answer

Blinks 6 times screen turns green and shuts down

Hi,I am pretty handy,I believe I can do the job but I do not have manuals.what type of cost are we looking at.
thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 121 Answers

I talked with my friend at the sight and he put your manual on the front page and its $19.99 has 157pgs and also he wanted me to remind you you also get free online tech support they also sell parts for tv's at very good prices
http://servicemanuals.vstore.ca/

Posted on May 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

AV-65WP84 when i connect video or the antenna the screen start to blink green does anyone knows about this problem on this jvc i-art tv?


Have someone open it from the front (front grill below screen is secured on either side at back with screws) and remove inspection plate behind grill--someone needs to locate the small black block with 6 adjustments and locate the green SCREEN not the green FOCUS and turn the green slightly down.

Care needs to be taken as set must be on--do not touch anything else inside as dangerous voltages are present when set is on.

Mar 16, 2012 | JVC Projection Televisions

1 Answer

Hi There... I have a sony kp-51hw40 and when I turn it on a green screen appears, then turns off and the standby indicator light begins to blink in sequence of 6 times each. can you help please or make...


The 6 blinks is happening be cause the set has lost high voltage and shut down due to the green CRT needing replacement. You should be able to get a replacement Green CRT from www.tvrepairworld.com

Jun 25, 2011 | Sony KP-51HW40 51" Rear Projection...

1 Answer

I have a Sony Wega LCD Projection 60wf655. When I turn it on, the red light turned green and blinks green 6 or 8 or 10 times or indefinitely. No picture but after a minute of being on the screen glows...


This could be the "thermal fuse" which usualy is next to the light bulb. Part cost around $5.00. Please check your manual for directions depending on light and times blinking.

Apr 11, 2011 | Sony Grand WEGA KDF-60WF655 60" Rear...

2 Answers

It appears something is wrong with the green tube. The picture comes on and then the green tube flashes and the TV shuts off and the LED blinks 8 times


This set has a history of bad picture tubes but there is an adjustment you can try to see if it will buy you some time to use the set further.

v\:* {behavior:url(#default#VML);} o\:* {behavior:url(#default#VML);} w\:* {behavior:url(#default#VML);} .shape {behavior:url(#default#VML);} Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Here is what you need to do.

1.) You need to remove the entire plastic piece below the front of the screen. You most likely will find 3 screws on either side in back that you have to remove.

2.) The grill will not come out easy, pull from one side and then when it starts to come loose from the other side(there are several plastic pegs that hold it in.) Then from the bottom pull out( most of these sets have square plastic tabs at the top that tuck in.)

3.) With the grill removed locate the inspection plate behind it (it usually has 6 screws.) You will have to tilt the grill to the left and on its side as several cables are connected to it--they are held in place with trash bag like ties that you can release to get some room.

4.) With the inspection plate removed you will see a fairly small (about 3 inch square) BLACK PLASTIC BLOCK WITH SIX CONTROLS-usually they are marked with whiteout so someone can tell if they have been adjusted.

5.) You need to look very close at the block with a flashlight----usually the top three controls are FOCUS--don't touch those.
The lower three are usually marked Screen and if you look very close you will see b, g, r(blue green red)

6.)Usually the GREEN will be in the middle.

7.) Once you locate the GREEN screen control have the set on and turn it down--if the set is shutting down you may have only a few seconds to try to turn it down---usually to the left with the Screen control.

8.) Best way to do this if the set is on is on a video input clip_image001.gif with nothing connected--you turn the Blue screen down until the set stays on and then very slowly turn it up until you see a slightly Blue screen with or without diagonal trace lines----turn it down slowly until the GREEN screen and trace lines just disappear.

Let me know if you get it to work--Like I said if it is shutting down you may have to slowly turn the screen down a few times to get it to stay on.


Regards, SD TECH

Apr 03, 2010 | Sony KP-51HW40 51" Rear Projection...

1 Answer

My SXRD 60" Sony LCD TV turns on. green light flashes about 6 times, then solid green. But just as screen starts to light up, turns off, solid green light turns red and blinks red four times, then stops. a...


Perhaps it needs the bulb, but there is also a good possibility that the lamp fan is getting clogged and shutting down the set. This is NOT the fan you see in the back, instead, it is above the lamp, and is a small blower-type fan, that tends to clog with dust. You CAN check this, when you open the lamp door,you can see the blower wheel, and if it is all dusty, it needs to be cleaned out--but do NOT just blow it out, or you might clog the engine!! It needs to be removed, and cleaned out of the set.

But first...if the blower is not too dirty...try another lamp.

Oct 10, 2009 | Sony KDS-R60XBR1 60" Projection HDTV

1 Answer

Sony KDF-46E2000 - Screen Goes Blank


You definitely have a bad lamp. Sony rates the lamp life at between 4000 and 8000 hours. There are 3 things that effect the lamp life, listed in order of importance:
1) number of times the lamp is turned on and off. Every time the lamp is first fired, it takes life off the lamp. Customers I see that turn the TV on in the morning, leave it on all day and then turn it off on the evening can get up to 12000 lamp hours
2) ventilation. Be sure you have at least 6 inches of open space all the way around the set and that the vents are clear of dust and debris.
3) power. If the power is interrupted when the set is on, there cannot be a proper cool down cycle. The fans will run after you turn the set off to properly cool it down, if the power is lost this cannot happen. If your power is unreliable, buy a small UPS to let the set finish a cool down cycle

Occasionally a lamp will faill before the average lamp time due to being defective. from your purchase date it sounds like you got about average lamp time. Be sure to purchase AN ORIGINAL SONY LAMP as a replacement, becuase the aftermarket lamps are bad news, Be sure to rate this solution. Thanks!

Oct 13, 2008 | Sony KDF46E2000 46" Projection HDTV

2 Answers

Sony KP-51WS510


you need a green CRT thats whay you have the white kind of concave lines with the green screen. You can try adjusting the green screen control but you need anew CRT ( tube) the speaker cover has two plastic plugs that get removed on the lower edge os the grille which covers the two screws that hold the grille on. If you need more assistancr or where to get a green CRT let me know as I have a link that has some green and red Tubes for your model.

Sep 05, 2008 | Sony KP-51WS510 51" Rear Projection...

4 Answers

Green flashes then tv turns off


or a new lamp. you could first replace the lamp.
the screen might work fine for a couple of seconds, but then it fades away or deteriorates. This means the lamp is going bad.

Aug 23, 2008 | Sony KP-51HW40 51" Rear Projection...

1 Answer

Powers on regular to total green screen,light flashes 6 times


the +5V line is either shorted or overloaded on the A & B board I reccomend a qualified tech do that repair unless you feel comfortable doing this but you will need a service manual for your set if you dont have one please let me know I can post a sight where you can get one with free online tech support

May 06, 2008 | Sony KP-51WS520 51" Rear Projection...

1 Answer

SONY KP-46WT520


does the led blink when it shuts down if so how many times does it blink? And the green line is that running up and down the screen or across the screen?

Apr 26, 2008 | Projection Televisions

Not finding what you are looking for?
Sony KP-51WS520 51" Rear Projection HDTV-Ready Television Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Projection Televisions Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Ap12
Ap12

Level 2 Expert

103 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sony Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...