Question about Televison & Video

1 Answer

Power up problem

Hi ! I was told that my problem was with the power supply board. I have replaced it and the problem is still there. When I plug the TV in the AC outlet, a relay on the power supply board keeps clicking and two small surface mount red LEDs on the main board flash. This cycle repeats itself a few times and stop. At this point both the POWER and OPC lights on the front panel flash. I hope you can help.
Thank you.
Luc Perron

Posted by on

  • 3 more comments 
  • norrep May 07, 2008

    The TV is a Sharp Aquos LC-52D64U

    Thank you for your reply !

  • norrep May 08, 2008

    If it could help you in any way I have the schematics for the Sharp LC-52D64U in PDF format. Is it possible to send them to you ?

  • norrep May 08, 2008

    I am sending it to your yahoo address. Good luck!

  • norrep May 08, 2008

    Please send me annother email address since it did not work with the one you gave me.


  • dissidentt Mar 20, 2009

    When powered on there is no screen and the power light flashes twice for everytime the opc light flashes once.


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 8,617 Answers

I will need the model number of your set in order to help you with your problem. Please post the model number and I will try to help you out with the problem.

Posted on May 07, 2008

  • 2 more comments 
  • Sonny Berry
    Sonny Berry May 07, 2008

    I am searching for info on that model so far I have found no service info what so ever other than it was produced in conjunction with Dell. I will contact you as soon as I can locate the service info or schematics.

  • Sonny Berry
    Sonny Berry May 08, 2008

    yes, you can send it to and I will look it over and give you some help on it. If its over 10MB yahoo will block it, but if that happens let me know and I will post an alternate email address of where I work

  • Sonny Berry
    Sonny Berry May 08, 2008

    ok as soon as I get it I will look it over and contact you on what to look for in the power supply.

  • Sonny Berry
    Sonny Berry May 08, 2008

    you can send it to me at work


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi plasma lg tv 42px4mvh-ta when i switch on it does's not switch on, i contacted technician the Guy told me that the main power supply board has a problem of suppling power how will you assist me

Fault to the main power supply regulator section. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.

Jun 15, 2016 | LG 42PX4DR 42 in. Plasma TV

1 Answer

Hi! I have a question about my LG 55LS4500 55" LCD TV. It started out as a dark cloud on the bottom right corner and now it is starting to spread. I was told I may need the LED Panels.

Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.
To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement.

Oct 13, 2015 | LG Televison & Video

1 Answer

Philips 52PFL7422D/37 TV is $2200 piece of junk... cant believe it wont work (no picture no sound) after just over 2yrs... I use to get picture and sound when i played around with the on/off switch...

Yes,it is the power supply board problems.The power supply board,that board where the power a/c cord plug into it.U have all the tools,know basic eletronic and basic soldering?Yes,check the power supply board for those dying parts call capacitors.These capacitors that are dying,it alway will bulges up or puffing up on it tops.By checking the power supply boad and replaced all these dying capacitors,will solved ur tv powering up problems.Or tries websites like, to buy a whole refurbish power supply board for the replacement.

Dec 02, 2010 | Philips 52PFL7422D/37 TV

1 Answer

In 42"panasonic plasma tv, standby red light would flicker then rather than turning into green and starting tv, it would turn off. I called plasma tv repair center at sion and vashi, they said that in Y...

Tv having a power supply board problems,not giving the tv the right voltages anymore.That the board,where the power a/c cord plug into it.Try website like to buy a refurbish power supply board for the replacement.

Oct 23, 2010 | Panasonic Televison & Video

1 Answer

Dell tv model w2600 - sometimes th tv will not turn on. However if i unplug the electric plug and then replug it, the tv will eventually turn on again. I have been told the power supply could be the...


Your power supply board is dead, u know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like, to buy a whole refurbish power supply board for the replacement.

Hope this help in solving the problem. Take care....

Oct 01, 2010 | Dell W2600 26 in. LCD Television

3 Answers

Hi iv got an nec 50 inch plasma tv model number pxt-50xd3 and i was told there is a power supply problem i was wondering if this is common and approximately how much will it cost me to fix?

Hi There I also have a nec 50inch plasma pxt-50xd3 its now not working. I have taking it to the repair shop who told me it was the power supply and it would cost me $550 to fix it.

Aug 30, 2010 | NEC PXT-50XD2 50 in. Plasma TV

2 Answers

Hi there I have a lg 50" plasma Model DPD50X30010. It does not turn on. When I power it up it clicks and then clicks again and Turns off. Could that be the power supply need help

Yes,it the power supply board.If u know basic electronic's,have tools and know how to do basic soldering?Take the tv aparts.The tv power supply board,that the board,where the power a/c cord plug into it.Searches the power supply board,look for those dying leakages of gases,going to be dead parts call capaitors.They alway bulges up on it tops or puffing up on it tops.Replaced these dying,going to be dead capacitorsThe tv power will be stable again and work.Or tries, to buy a refurbish power supply board for the replacement.

Aug 02, 2010 | LG 50PX1D 50 in. Plasma Television

2 Answers

Sanyo clt 2054 dead.just a clicking sound, no picture no sound no power light. replaced main board same problem.


As there is no Power, there seems an issue with Power Supply. Might be a blown capacitor.

Do you hear any sound when you Plug on the LCD and the Button?

What i assume, it has to be the Faulty Power Supply Board. As you are not getting any power , you should have check the power supply board followed by main board .

Check the Power supply board and invertor circuit and replace it, if Faulty.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Aug 02, 2009 | Televison & Video

1 Answer

With no picture but only sound on my Akai PDP 4294

Try replacing the Y-sustain board. Might have to replace buffers attached to it too. Have you had it diagnosed? My picture went out and I replaced the power supply board. Worked for 2 weeks then acted up again. Got a different power supply board. Same thing 2 weeks later. Was told it now was a bad Y-sustain board. Replaced y-sustain board. Worked OK for about 2 hours then started having picture issues. Not the same issues before power supply or y-sustain problem. Was told that you might have to replace buffers attached to y-sustain when you replace y-sustain. Tired of dealing with it and only watch a couple hours a day, so I don't always have the problem unless I watch the TV for a long time. Will eventually replace buffers to see if that works. I would definitely find a place that gives free estimates or close to free to get a technician diagnosis. Then you can decide if you are able to do the work yourself.

Jun 06, 2009 | Akai PDP4294 42 in. EDTV-Ready Plasma...

2 Answers

Supply board


The power supply board for this model can be found in the link below.

Buy PDP-5030HD Power Supply Board

Mar 20, 2008 | Pioneer PureVision PDP-5030HD 50 in....

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

812 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69878 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6445 Answers


Level 3 Expert

64052 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides