Question about Garland H283 Gas Kitchen Range

2 Answers

Gaffers and Sattler vintage stove oven pilot 1956 W54 series similar problem

After we moved our Gaffers and Sattler W5494 stove, nothing I could do would light the oven or broiler pilots, although they were working fine before, and all top burners are working fine...I have the original manual, it implies that all you need to do is "light the pilot on oven" but says nothing about a reset switch and no reset switch is found anywhere...pilot gas goes to top burners directly, no safety valve, but is there a safety valve for the oven and broiler? Why would they both suddenly stop lighting? Is is something electrical? There is no smell of gas. To clean pilots is the obvious, but does not solve the problem...someone, please help! the safety valve appears to only control the actual gas to the oven from the thermostat, but has nothing to do with the continous pilot. thank you, cody and florence, venice, CA

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

If you lift up the griddle, or the burner trays, then if you look along the sides toward the back of the range, you should see a button on each side. Usually the buttons are red. They are easy to spot. Assuming that the pilots is lit in your over, and in your broiler, then depress the red button while turning on the gas. Do this once for the oven, and once for the broiler. If everything is working right, then you should not have any more problems.

Posted on Jan 10, 2013

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My mother had the same problem with her Gaffers-Sattler range. No one could figure out what was wrong with it. Her local new appliance repair people said to contact J.E.S. Enterprises, Inc at www.theoldapplianceclub.net. Whew; thank God for that tip. They knew exactly what the problem was and repaired the unit for her. The stove is running again like a workhorse! Here is their number - 805-643-3532.

Bob Allen

Posted on Nov 24, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to light pilot light with sealed broiler oven


What make and model is it? I maybe able to help.

Aug 25, 2016 | Kitchen Ranges

1 Answer

I have a 1965 gaffers & sattler wall oven with the oven on the top and the broiler on the bottom. It began having issues lighting even though the pilot light was on. Now the burner doesn't light up at...


My Mom has a 1965 Gaffler & Stattler Mark 21 wall mount oven, it had the "Same Problem", People may tell you that the flame switch is no longer avalible but I found a universal fit flame switch at Applance Parts Center, I took the old part in and had it matched up, with a minor modification to the thermal sensor mounting bracket, "drilling a larger hole and lightly crimping it", it's a perfect fit, "problem solved". You may want to try cleaning the pilot light area with a small wire brush first, if that dosn't work try a jumper wire on the two terminals of the flame switch, if that works then replace the flame switch.
This operation can be done without removing the oven from the wall mount, just remove the two screws from the panel at the inside rear of the broiler, you will find the flame switch behind the panel it has two screws two wires a thermo leed and a sensor tip that goes up to the thermo sensor mounting bracket above the pilot light, the thermo sensor mounting bracket has one screw and a nut behind it, you will also need to remove one end of the 1/4" pilot gas pipe in order to remove the thermo sensor mounting bracket, When your done puting it back togather, check for gas leaks using soapy water in a spray bottle, a dish soap solution works great, also check your vent pipe connections.
After I cleaned the dust and grease out of this old thing, the 45 year old clock and timer started working again.
My Mom is very happy, try and find new oven to fit the cutout and vent, we saved a lot of $$$,
"Good Luck".

Nov 18, 2010 | Ovens

1 Answer

HEATING ELEMENT GAFFERS & SATTLER BUILT-IN OVEN


our 1985 gaffers and sattlers oven would not turn off tonight. Any idea? Its Propane oven

Dec 22, 2009 | Ovens

2 Answers

Problems with Brown Stove Works TM110-3 Gas Kitchen Range


http://www.brownstoveworksinc.com/pdf/gas_manual.pdf

there you go, the complete manual to operate your stove. look on page 16 to read about the pilot in the oven and how to proceed.

May 20, 2009 | Brown Stove Works TM110-3 Gas Kitchen...

1 Answer

Can't find the oven pilot on an old Gaffers and Sattler "Energy Saver Range with Uni Burners"


With the help from your site I was able to hold a match under the bar under the oven shelf toward the back and light the pilot. I am SO grateful. I hadn't been able to see it but just held a match toward the back, and it lit.

Feb 27, 2009 | Garland H283 Gas Kitchen Range

1 Answer

Old Gaffers& Sattler oven won't heat up. I suspect timer setting?


The most common failure in any electric oven is the heating element.

Jun 20, 2017 | Ariston Technologies Ariston FO98P...

1 Answer

Gaffers & Sattler stove


The pilot is under the bottom oven deck, usually you can lift the front edge, and slide it out, smelling gas without a pilot would be bad, that means either A : your safety is bad, and allowing gas to flow anyway, which requires replacement, and you may as well replace the thermocouple, and clean the pilot. or B : it is old enough it does not have a protected pilot, and you have to manually light it, usually indicated by an open hole in the front middle of the oven deck plate when you open the door, with a tube going to the burner. or C : your oven burner is bad or misaligned with the burner, and is shooting gas away from the pilot area, it would light via an open pilot eventually, but you don't want that. Please let us know, or have a qualified servicer look at it. Happy New Year, and thank you.

Nov 19, 2008 | Garland H283 Gas Kitchen Range

1 Answer

GE Spectra oven not lighting


you need a new oven ignitor for bake if its a gas stove..

May 26, 2007 | GE Profile Spectra JGBP90 Gas Kitchen...

Not finding what you are looking for?
Garland H283 Gas Kitchen Range Logo

2,104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garland Kitchen Ranges Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers

Dennis Boxerman

Level 3 Expert

1230 Answers

Are you a Garland Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...