Question about HP Computers & Internet

1 Answer

My Packard Bell tower tries to boot up but there is a long beep and the vdu says there is no signal

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • HP Master
  • 27,725 Answers

Test your PSU or replace it
Test all leads that attach to your hard drive including electrical extensions,IDE,SATA and
the leads from your motherboard to your hard drive make sure they have a secure connection and are not faulty or just replace them there probably old and faulty
good luck

Posted on Aug 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Packard Bell OneTwo M3700 PC boots up but no display


most of the time on older monitors you can set the refresh rate in safe mode and that will, most of the time, resolve the problem otherwise time to purchase a newer monitor.

Jun 26, 2015 | Packard Bell Computers & Internet

1 Answer

Packard bell imedia d3318 no vga signal


It is the video graphics card, or the motherboard, but you can sub out the ram memory one at a time as you test. It might be a bad stick of ram which would rule out the above mentioned

Apr 10, 2012 | Packard Bell iMedia Computers & Internet

1 Answer

My pc powers up but wont boot up and has no beep also no power to my key board


I have a Packard Bell motherboard MS-7301 VER:1.0 The computer does not boot up. The computer is about 4 years old model type UTOW - CUB SERIAL # 049924520227 Any solutions?

Jan 21, 2011 | Packard Bell (181678-03) Motherboard

1 Answer

My packard bell imedia will not boot, when i press on button it goes red instead of blue and the shuts off after 2 seconds


i'd say your not passing the post test....if you hear a beep when you start your pc it should boot to windows screen if you dont hear beep you could have a loose cpu fan open up pc and make sure the fan is secure if not try tightening it can be tricky either that or it could be your power supply i wouldnt attempt fixing that if not sure what your doing..or try turning off your pc plug it out disconnect all periphals and press in the on button and hold for 2 minutes then try and boot

Aug 05, 2010 | Packard Bell iMedia 6826 (P481000502) PC...

1 Answer

I have lines and my compter in not right


Hi,
The step , you can do to check if the problem is with the computer tower or only the monitor is
1. Unplug the signal cable ie connected from the monitor to the computer tower.
If the lines are still there after disconnection of the signal cable there could be a problem with the monitor.
2. If the lines go away , try reseating the cable and check


Thanks
proton

Oct 01, 2008 | Packard Bell Computers & Internet

1 Answer

Computer starts but screen is black,fan is running,hocked up moniter but no signal being sent??? packard bell easy note


check the primary memory or the RAM chips as it is called...

try booting with single chip if 2 are present..it may be the problem

Aug 13, 2008 | Packard Bell Computers & Internet

1 Answer

Packard Bell error signals


here is a list of packard bell beep codes with meanings
http://www.uktsupport.co.uk/pb/mb/phnxcode.htm
Hope it helps you

Nov 13, 2007 | Packard Bell Easy One Silver 2101 Notebook

1 Answer

PACKARD BELL COMPUTER TOWER


Hi, sounds like your hard drive is going/gone flaky...  & if so ya gonna haveta get a new hard drive & a Windows Operating System. 

Or take it to a good PC repairer, and get a quote and  explanation.

Oct 15, 2007 | Computers & Internet

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18394 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Tony

Level 3 Expert

2600 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...