Please, a circuit diagram for a Behringer B2 Pro microphone, showing components and schematic for the two internal boards. Working on one for an associate and doing it for nothing. thanks in advance, Edward.

There is no Service Manual for it.

https://www.google.com/search?q=Behringer+F1320D+service+manual

and no wiring schematic.

https://www.google.com/search?q=behringer+f1320d+wiring+schematic+diagram

Contact Behringer Support direct


..

What you are asking for are the design drawings, which are usually proprietary and not published by the designer.

This is not a stereo microphone. There is no left channel. If you are recording into a stereo input, you need to split the input into two mono inputs, and record each channel as a mono track.

Behringer will not release schematics unless you are an authorized service agent... however, sometimes you can make do with the few schematics floating around... What is the problem with the unit? They typically use a switching power supply and the schematics of those aree usually similar enough to repair them.

This microphone requires phantom power to operate.

Right here............
http://www.behringer.com/EN/Products/fcb1010.aspx

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

Here is the manual:http://www.behringer.com/EN/downloads/pdf/MIC2200_P0054_M_ENG.pdf Plug your microphone into the input using a proper cable. Plug another balanced cable into the output on the back and plug it into a microphone input on the mixing board. If your mixing board already has phantom power, disable it for that input as the MIC2200 has phantom power. Read the manual carefully and take note of the directions for phantom power and balanced cables. Make sure you follow the directions carefully. If you need the manual in a different language look the MIC2200 up under products at Behringer.com and you can download in pdf format in many different languges.

Behringer only gives schematics to their authorized service people.

I find I can usually trace stuff out as needed as the mixers are a very symetrical repeating circuitry.

Most components are readily available from other sources.