Question about Brother MFC-8440 All-In-One Laser Printer

2 Answers

Faxing I just replaced the left hinge i ordered from Empire Office Machines. Now when i try to fax it says "check original"

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi dchaz,

with the indulgence of bestdarngood...

Pls recheck how the "new hinge: was installed and/or if it matches exactly the old one As it may not have aligned properly, this mis alignment will cause the lid cover not to be seated properly and a sensor/switch sense this thus the error display.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on May 06, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,037 Answers

How to clear the "Check Original " error message? Description: This error can occur if the document being sent or copied is not inserted properly, fed incorrectly or is too long. Follow the troubleshooting steps and recommendations listed below:

  1. Remove any paper that is not jammed from the ADF.
  2. Open the top cover by lifting the lever on the right side of the top cover.
  3. Pull the original toward the front of your fax machine.
  4. Close the top cover. Press down on both sides of the top cover until it clicks.
faxing - jam06.gifBefore placing the document(s) in the Automatic Document Feeder (ADF), verify the error message "CHECK ORIGINAL" no longer is displayed on the LCD. If the error message continues to appear on the display, unplug the unit for 30 seconds and then plug it back in.




Let me know if you need any further help

Posted on May 06, 2008

  • Benjamin Patri
    Benjamin Patri May 07, 2008

    Please don't forget to let me know your thoughts about my solution.





    If your problem is fixed, please rate this solution as that is one of the biggest
    aspects of how this website works and in order to receive any credit in
    helping you, I need to be rated.










    Otherwise, let me know if you have further questions and I would be glad to help.











    Thank you

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I use the fax machine?


Do people still fax..? I thought it was all E.Mail nowadays, Anyway
as I remember it, most company's had a FAX number very similar
to their Phone number yeh..? you would put the fax sheet in one end
Dial the comp. fax No. and it would start to fax through when the Fax machine at the other end answered just like a phone call works.
You are left with the original fax sheet and the fax machine would print
off a copy of what you sent it,and vice versa.I doubt however there are
many companies still using fax machines anymore,it's much easier to
E.Mail...T.C.

Mar 31, 2013 | Lexmark X5320 USB 2.0 All-in-One...

1 Answer

"remove and check left cartridge", replaced with new + same err m


Carefully read the user manual given with the AIO. Check the settings to keep the AIO in "FaxTel" or "Fax" mode to receive incoming faxes.

Sep 16, 2009 | HP OfficeJet 4255 All-In-One InkJet...

1 Answer

Got new hp elite m9402f computer but new hp fax doesnt answer


hi there,

initially you have to check and correct this few settings.

To receive a fax manually

1. Make sure the device is turned on and you have paper loaded in the main tray.

2. Remove any originals from the document feeder tray.

3. Set the Rings to Answer setting to a high number to allow you to answer the
incoming call before the device answers. Or, turn off the Auto Answer setting so
that the device does not automatically answer incoming calls.

4. If you are currently on the phone with the sender, instruct the sender to press Start on their fax machine.

5. When you hear fax tones from a sending fax machine, do the following:


a. Press the left arrow or the right arrow to select Fax B&W or Color fax.
b. Press Start.
c. After the device begins to receive the fax, you can hang up the phone or remain on the line. The phone line is silent during fax transmission.

Hope this initial info helps you.

micromaster-

Jan 19, 2009 | HP J4680 Office Jet All-In-One Printer

1 Answer

Brother mfc 8440


This is commonly a problem with the left hinge being broken on the lid where the adf is. Check that and if it is broken i can give you a part number.

Good luck!

Sep 03, 2008 | Brother MFC8440 Remanufactured Laser...

1 Answer

Busy/No Response


Using a cell phone, call your fax machine to see if the fax answers. If it does answer, then hang up the cell phone and fax. Next, using the HOOK button on your fax, call your cell phone . The cell phone should ring and answer the phone call from the fax. If you do not get a connection between the fax and cell, try these: Check that the phone line to the fax is plugged into the LINE jack on the fax, NOT THE PHONE jack. The PHONE jack on the fax is to plug in a TELEPHONE ONLY. If the fax phone line is OK, go into your fax machines' RECEIVE and SEND settings and make sure they are set up properly (pulse or tone dialing, overseas mode, etc.) Print out the HELP LIST as follows: Press MENU button, then 5 on keyboard, then 1 on keyboard. Go through all the settings on the HELP LIST that apply to your problem. (Send and Receive modes, Ring Delay, Receive Options,etc.) Write down the original settings BEFORE YOU CHANGE ANY OF THEM.

Aug 25, 2008 | Brother MFC 420CN All-In-One InkJet...

1 Answer

FAX ANSWERS AND DIALS, BUT DOESNT FININSH THE JOB


have you try rebooting the fax or even unstall the software and then reinstall software.

May 21, 2008 | Brother MFC-8440 All-In-One Laser Printer

2 Answers

HP Office Jet 6110 All in One faxing


This document covers the basic fax functions of the HP Officejet 6100 series. The HP Officejet 6100 series can perform the following functions:
  • Send and receive paper faxes.
  • Send and receive color faxes. Color faxes can be sent only to color fax capable machines. If a color fax is sent to a black-and-white only fax machine, the HP Officejet sends the fax in black and white.
See Figure 1 below to identify the buttons in the Fax area of the front panel. Figure 1: Identifying the fax area of the front panel c00259777.gif 1- Turns Auto Answer on or off 2- Scrolls through speed-dial entries 3- Redials the most recently dialed number 4- Dials fax numbers, enters text, and specifies menu items. 5- Starts a fax 6- Changes the fax resolution 7- Dials one-touch speed-dial numbers Fax settings Most fax settings are configured during installation through the Fax Setup Wizard. These settings, and some additional options, can be accessed through the front panel menu (see Figure 2). Figure 2: Changing fax settings from the front panel menu

1. Menu: enters the menu system.

2. Right and left arrows: navigate the submenus and options.

3. Enter: selects a submenu or option.

4. Cancel: exits from the menu. c00259778.gif Sending a fax To ensure the best quality when sending faxes in color, use a color original instead of a color copy. Follow these steps to send a fax:
  1. Load the original. Load originals directly on the glass or in ADF. For multi-page faxes, you must use the automatic document feeder (ADF). Loading original on the glass Place the original, print-side down, on the front-right corner of the glass. Loading original on the glass c00259779.gif Loading original in the ADF Place the original, print-side up, in the ADF. Adjust the paper-width guide to fit the original. Loading original in the ADF c00259780.gif
  2. Enter the fax number using the keypad. Dial the number just as you would from a telephone (dialing 1 before an area code, etc.)
  3. Press Start Fax Black or Color.
  4. If there is no original in the ADF, the display will read, "Send from Glass? Press 1 for Yes or 2 for No"
    • Press 1 to scan the document from the glass.
    • Press 2 to load the document in the ADF. The display will read, Load original, then press Enter .

Apr 15, 2008 | HP OfficeJet 6110 All-In-One InkJet...

1 Answer

CHECK ORIGNAL


you have the problem with your adf on machine try to see where is sensor jammed or broken

Feb 28, 2008 | Brother MFC-8840D All-In-One Laser Printer

Not finding what you are looking for?
Brother MFC-8440 All-In-One Laser Printer Logo

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Brother Office Equipment & Supplies Experts

CheckitRight
CheckitRight

Level 3 Expert

1362 Answers

Soulvisitor
Soulvisitor

Level 3 Expert

1113 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a Brother Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...