Request hello ! I am albens from albania , and I need where to find a fuse for fusing unit of konica bizhub c250 to reset him.

The fuser unit is faulty. The fuser heats the toner so it melts the toner onto the paper.

Wait , i will upload video for you guys, so that you can reset Fusing unit by yourself.

I can only tell you they are definately resettable as I do it all the time.
The fuser "fuse" is located in the connector wiring. Once you get the fuser out just look in the area where the large connector is. It is a very small fuse similar to a resistor, green, and is encased in shrink wrap.
The Transfer belt fuse is behind a small black cover. If you pull the transfer belt unit out of the machine about 6 inches, it is located on the front right corner. In other words standing in front of the copier with the belt unit partially out it is on the corner closest to you. You have to remove a screw, a c-clip, a small metal plate and the small black cover is held on with a very small phillips screw.
He is the parts availablitity and part number info.
Fuses are available at http://www.digikey.com/
Transfer Belts
Replace glass fuse 80ma , counter resets automatically.
Item # 507-1218-ND
Fuser Units
Fuse is wrapped in shrink wrap. Cut it out and splice in a 1/16 ma fuse.
Item # F2307-ND
Good Luck and Thank You for using Fixya.

Hope this helps. Make sure you remove the waste tank prior to taking out the transfer belt. Belt is removed by two screws inside right door and sliding the unit out.

search in youtube you will get there, what you want,

to replace unit you will need open front cover and remove one screw in cover top right. Unplug two cables. Open right side cover and unplug two small connectorson the right of the fuser. Then remove two screws from the bottom of the fusing unit. and it should come out

Please visit the site http://www.resetkit.eu
There you can find how to reset your fusing unit and transfer kit unit for almost all Konica Minolta MFP's and printers, Bizhub C252 included.
You don't need to replace it, you can just reset it and save a lot of money.

Reset your Toners and Imaging units for Minolta Bizhub and CF series.
http://www.chipreset.eu

On your transfer unit there is a .80 amp fuse you can replace. this will reset your belt. make sure you use .80 amp or it will not work. on your fuser there is an inline 1/16 amp fuse next to the plug you can replace for that.

Yes,

Remove Trasfert belt unit.

On the left handled remove one screw ( spring fixer) and remove right srew (over the belt / bar whit finger fixee).

Remove, on the left spring stoppage and metal handled.

Remove black little srew and take to hand fuse contact.

Change fuse (behind) with new identical fuse and reassembly.

It may be reset trasfert belt counter.

Sorry for my not good english.

Bye.

reset life of actual transfer