I can not fold my bebecar raider at stroller - Bebecar Raider AT Stroller

Hi Sandra,

We recommend you contact BebeCar directly for assistance.

To fold a Raider AT pushchair, first make sure that the front wheels are locked into the non-steerable mode. Next, look at the twist-grip in the middle of the handle. Press the central red button and simultaneously turn the collar in the direction of the arrow. The chassis should begin to close at this point.
Then find the lever on the side that operates the secondary locking device. Tilt the chair forward and continue folding until it is fully closed. It may be necessary to align the front wheels with your foot in order to enable the chair to close fully.
An instruction manual, with diagrams, is available from [email protected]

To unfold the Raider, first press the red button in the middle of the handle and then twist the twist-grip in the direction of the arrow. Once you've done this, keep it twisted while you place your foot on the horizontal footplate. Once the chassis starts to open, pull sharply on the handles until both the primary and scondary locks engage. Make sure that the red latch is not visible, and check the security of the primary and secondary locks by gently pulling on the handle and pushing on the left and right mouldings.

Find out more by requesting a user-guide from [email protected]

You fold the Raider by turning the twist grip in the centre of the handle down, this releases the primary lock on both sides. You then need to release the secondary lock which is located just below the rubber handle grip on the right side. If the secondary lock is not lifting, it may be that the rubber grip and moved down slightly, inch the rubber grip up and try the secondary lock again. You can obtain instructions by emailing [email protected]

To fold the Raider AT you need to turn the twist grip in the centre of the handle in the direction of the arrow. The secondary lock is located just below the rubber handle grip on the right side, slide this up. You can obtain instructions by emailing [email protected]

There's no reason why it should fold during use, if it's locked in properly in the first place, that is. To be safe, you could contact your retailer, or Bebecar U.K. direct. 01692 408807.

To fold a Bebecar Raider AT, first make sure that the front wheels are locked in non-swivel mode. Next, press in the central button and turn the twist grip at the same time. The chair will begin to close. Next, operate the secondary locking device by pulling on the plastic catch. By tilting the chair forward, complete the folding operation.
Full instructions can be provided by e-mail from [email protected]

get in touch with east coast nurserys they are the distubitors for bebecar. or if you live in london get in touch with www,buggypitstop.co.uk and they will fix it for you

Press the central red button on the handle and twist on the twist grip. Place your foot on the horizontal bar (that the basket is attached to) and push down on that at the same time as pulling upwards on the handle, until the chassis is locked in.
You can obtain instructions for your Raider AT by e-mailing [email protected]

Press and twist the release button in centre of handle (twist towards seat), while simultaneously pulling up the secondary release on right hand side of handle (just where the rubber grip ends). There is a red dot on each of these so they can be identified.

We had the same problem a few months ago - hadn't used it in a couple of years - had to pull out the manual.

Hope this helps