I have a second hand philips sbx6. I need the instructions for connecting the i/c lines and extensions to the wall mounted connction block. Can you help.

Usually there is a set screw in the side of the wall mount. If there is loosen that and take the towel ring down. There maybe a second nut or fastener you can tighten up the ball with. If not just buy another one. Some just get worn out over time its normal.

It sounds like there is a obstruction in the line. disconnect the connection from the reel to the hose shutoff and blow the line out with compressed air.

the mount manufacturer may have extensions for the mount. if not you may have to purchase the one designed for that tv. Try Sanus mount finder.

Apparently you need some kind of MOUNTING SCREW EXTENSIONS to mount your tv to the wall.

You will need to contact Philips Customer Service at 1-800-705-2000 to order them.

See page 5 of your tv's USER'S MANUAL at the following link:


http://download.m4c.magnavox.com/files/2/26md357b_37/26md357b_37_dfu_aen.pdf

Good luck and please comment back if this was helpful.

I lost mine too, saw this post, and then they turned up, so here you are:

COMMTEL
Surface Mounted 2/6a Slave Wall Plate - with ADSL Filter

Instructions

• Remove wall plate back box by removing the two screws on the front face
• Fix wall plate to skirting board or wall with screws supplied, allowing adequate space for cable entry
• Insert exisiting telephone wires into screw connections on the ADSL face plate, following cable colour coding according to the list below, and ensure screws are correctly tightened
• Screw wall plate onto the back box with the screws supplied, ensuring screws are sufficiently tightened

Cable Colour Coding
1. Not Used
2. Blue with white banding
3. Orange with white banding
4. White with orange banding
5. White with blue banding
6. Not Used

Information

• No need for external filter
• Surface fitting, replaces existing wallplate
• Quick set-up
• With back box

* If more than one phone or fax IS required to run off the same line, simply add more filters where required. Each individual piece of equipment will require a seperate ADSL filter
* Multiple telephone connections, long runs of cable (over 20m) or low quality telephone cable can adverely effect the performance of your connection speed

Safety Information
Before carrying out any electrical work, always switch off at the mains. If in doubt consult a qualified electrician.

Item Code: 41603016
Distributed by Commtel UK Ltd
www.commteluk.com



It might be worth mentioning that this filter swaps the polarity of the telephone wires: I don't know why. I rewired mine to use it as a master socket, and I have connected the other extensions to the filtered output. This can improve broadband speeds: see
http://www.rob-r.co.uk/other/UKphonecatwiring.htm

On the left side of the printer there are two telephone line connections, one is for the telephone line and the other is for the telephone extension. You will need two telephone lines, the type that have that clicker on the end, the line hole goes directly into the wall jack for the telephone and the extension line goes directly into the telephone that you had plugged into the wall. Try that, it works.

A short pilot flame not playing on the thermocouple or a faulty thermocouple , loose connection at the gas where thermocouple is ,

blocked pilot flame to small , air in gas line did he purge the gas line first? other wise you will be there a long time .

You may need to assign an intercom ID for that unit by pushing one of the intercom buttons at the top.

check your handset, is it placed properly