Question about HP OfficeJet 6110 All-In-One InkJet Printer

1 Answer

Hp digital copier 610

Same problem carriage jam I donot a have a # key how do i do a hard reset

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

You have to get the code from HP support, hovever, the problem is probably the cleaning station jamming the carriage and a reset won't help

Posted on May 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to clear carriage jam?


Hi there! in order for you to clear the carriage jammed of your 7410.. kindly check this link below..
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00304007&tmp_task=solveCategory&lc=en&dlc=en&cc=us&site=null&key=null&product=391194

if the steps didn't help you on how to fix the carriage jammed then there's something wrong with the printer itself.

May 17, 2011 | HP OfficeJet 7410 All-In-One InkJet...

1 Answer

HP 6110xi -clear carriage jam


LOOK BEHIND THE CARRIAGE IS A SEE THROUGH CALIBRATED RIBBON WHICH NEED TO CLEANED, IF IT DOESN'T WORK THE SENSOR BEHIND THE CARRIAGE MUST BE CLEANED

Nov 06, 2008 | HP OfficeJet 6110 All-In-One InkJet...

1 Answer

HP Digital Copier 610 Carriage Error


Depending on where the paper jam happened and how you cleared it, you could have either "knocked the copier for a loop" or actually damaged the print carriage. The first thing I would do in your shoes is to turn off the copier and unplug the power cord from the back of the product.

Wait about 30 seconds or so to make sure any errors being held in the copier's memory by any residual electrical charge clears.

Plug the power cord back in to the back of your product and turn it on. My guess is that you'll be prompted to go through a cartridge alignment procedure. That may well clear up the problems you see.

Just in case, I'm posting a link to HP.com to instructions on how to clearn the electrical contacts on the print cartridges and print carriage. There are also instructions on this page regarding latching cartridges. These seem to be fairly easy processes, but if not done correctly, can result in continuing errors:

Resolving Print Cartridge Errors

Print back your results and good luck.

Nov 05, 2008 | HP OfficeJet 6110 All-In-One InkJet...

2 Answers

Carriage jam


proper servicing will solve the problem.
try hard reset.
rate the solution as fixya if it helps you.

Jun 24, 2008 | HP DeskJet 882c InkJet Printer

1 Answer

Carriage jam


Try this (it may not work) -
Perform a Semi-full Reset on the unit by following the steps below:
1. Make sure that the unit is on, and disconnect the power cord from the back of the unit.
2. On the unit keypad press the # and the 6 keys simultaneously and hold both keys down while plugging in the power cord.
3. The Semi-full Reset message will appear on the unit display.
Wait until the unit initialization process is complete. The unit will have recovered its original settings.

I've had this error before and had no obvious fault with the carriage (it moved freely and the encoder strip was in place) i managed to clear the error by stripping the printer down and cleaning around the service station area

May 29, 2008 | HP OfficeJet 6210 All-In-One InkJet...

2 Answers

Carriage jam error


Hi,

Perform a semi-full reset on the all-in-one by following the steps below

1
Take out the cartridges from the unit .
2
Make sure the unit is connected to the wall jack directly without any surge protector.
3
Unplug the power cord from the back of the unit ( without turning off the unit ) .
4
Now press the # and 6 key together , while holding these keys down plug in the power cord back into the unit .
5
Do not release the keys after a few seconds u will find te hp logo or bars moving across the screen .wait while the unit turns off.
6
after one minute turn on the prnter . it will go into alligment phase > let it finish .


7 Allow the all-in-one to re-initialize. This may take a minute or two.

8 If prompts appear in the all-in-one display to set the front panel language and country settings, perform the steps to set this information

Thanks

May 27, 2008 | HP Photosmart C7180 All-In-One InkJet...

2 Answers

Carriage Jam error always - how do I fix it?


Try resetting the printer (pressing the cancel button and connecting the power supply, check in the HP website if this is correct for your printer model) , after the reset the printer will clear any errors and will recalibrate the mechanism including the paper feed mechanism and the carriage.
Also check if the carriage is moving freely by disconnecting the power and moving it by hand.

Jan 21, 2008 | HP Photosmart 2710 All-In-One InkJet...

4 Answers

Carriage Jam


I FIXED MINE YES... open your thing.. and look,... do you notice..
theirs like a small black.. corner shaped thing, that stopped the carriage..

pop that thing like add force to push it back...
boo ya. :) and their you go...
this problem annoyed me for a month. and i went through numerous hp printers too.
but, just...... really open your eyes and try to find out whatsup..

:) woot woot woot imma print stuff now.

Nov 01, 2007 | HP OfficeJet 6210 All-In-One InkJet...

Not finding what you are looking for?
HP OfficeJet 6110 All-In-One InkJet Printer Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Printers & Copiers Experts

kakima

Level 3 Expert

96417 Answers

k24674

Level 3 Expert

7987 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a HP Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...