My barrel is twisted and cant turn it back to normal on my crosman quest 1000

available here

Replacement spare parts for Crosman Quest 1000 Storm XT TAC 1 Extreme...

Pull the firing pin and check it for freedom of movement and damage to the striker.

The barrel should not turn. Exchange the gun.

You load one pellet at a time when the barrel is broken open, the chamber is in the break of the barrel. One stroke, load, close, shoot, keeps you in shape. the old Sheridans, 10 pumps, really kept you in shape.

Can you see through the barrel? Or run a rod down the bore? It sounds like the BB is either falling out the end of the barrel or the BBs are getting jammed up in there. Do not hold your hand in front of the barrel to see if any air comes out. You might get stung with 10 BBs. Hope this helps.

I had the same problem, it wouldn't click or stay c.o.c.k.e.d when I did a typical barrel break. I took apart the back end where the3 spring was. (screw and pin must be removed once you take the barrel out of the stock.) I found that it was the "Back Spring Guide" that was broken, but not completely, I turned it, put it back together and it worked for about 9 more shots. Then the same thing happened, so I know that I need a new one. Here is the Part # B18‐00‐6 here is a link to the part breakdown pdf from Crosman's site.
http://www.crosman.com/pdf/manuals/C1K77%20C1K77X%20%20EVP%20&%20PL.pdf

I just called customer service at 1-800-724‐7486 but they close at 4:30pm eastern time, I left a message.

I cannot find anywhere online to buy that specific part, so I assume that it has to come from Crosman. I'll let you know how I make out.

If anyone knows where to get Crosman parts, please let me know.

Thanks
MD

The piston doesnt lock on the trigger. if trigger is adjustable set adjustment more coarse. Check also sure that trigger mechanism is in forward position and not stuck halfway. If still not hooking see if piston hooh and trigger catch not damaged. very seldom the piston will twist inside making it impossible to hook, just realign piston.

Are you trying to say it will not c.o.c.k.? (dang sensors.) If so, you have to slap the barrel pretty hard toward the front or tip of it. Hold gun firmly and bang that barrel good with the palm of your hand. It should then break open the barrel and be ready to load and shoot again. 

Tapped barrel with Rubber mallet gently. Assembly broke loose after two attempts.

crossman customer service ph#1800 724 7486 start here they may
have it