Question about Bryant 462AJC021BA Air Conditioner

1 Answer

Ac compressor runs, no blower fan. fan and capacitor ok. bryant

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 107 Answers

So the outside compressor and fan are working good ? If the fan and capacitor check out good then check that the wire from the thermostat for the fan (usually green and tied to grey on a bryant) has voltage and if it does the control board needs replaced because it contains the fan relay

Posted on Aug 20, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 4 ton Bryant air conditioner shuts off, fan still runs but not cooling is problem in the controls in the attic or in the AC unit or both?


With a non heat pump it is a simple 24 volt AC control circuit. In the attic there is a relay that is actuated via the fan control wire directly from the thermostat. On the thermostat there is an auto/man switch that controls the fan. Manual the fan runs all the time. Auto fan turns on and off with the outside compressor.

If the system is not calling for cool and the fan continues to run the fan relay is sticking. common problem. Sometimes after running for several days the relay will stop sticking if not, replace relay.

If the system is calling for cool and the compressor stops I would still expect the fan to run until thermostat tells the A/C to off. Some compressor units include a safety switch or high-pressure cut-out switch A blocked internal valve bad control board or external fan in outside unit defective no air flow in outside unit.
High pressure cut out not good,

Suggest turning temp max cool and observe. If acceptable cool and the compressor runs without interruption all is good, except for the blower in the attic. Safely check relay in attic blower circuit.

Hope this helps.

thermostat-heat-cool-fan-on-czwsw2ci0layswcsyy3dj4dr-4-2.jpg

basic-thermostat-wiring-diagram-czwsw2ci0layswcsyy3dj4dr-4-5.jpg

Jun 28, 2017 | Bryant Heating & Cooling

2 Answers

Compressor runs but why is no air coming through ducts?


The fan motor may have gotten zapped. Something, such as a line surge, may have affected the controller.

Sep 11, 2015 | Bryant Single-Packaged AC & Gas Furnance...

1 Answer

Bryant condenser not running.


Check that there's power available (open or tripped breaker or disconnect). If there's power available, check for 24-28 volts feeding the contactor coil. The low refrigerant cut-out may have tripped the 24v (leak). The pressure cut-out may have tripped (dirty condenser coil, inoperable condenser fan motor). If there's 24 volts at the contactor coil, check the capacitor before ohming the motor. A defective run capacitor will shut the compressor down.

Aug 27, 2013 | Bryant Legacy 16 Series 4.0 ton AC...

1 Answer

Having problems with my bryant 601a package unit blower is working and moving air but not cold my unit fan is turning off and on but not sure the compresser is working i replaced the capacitor any other...


I would check to make sure the compressor is in fact working (people sometimes mistake the condenser fan being on for the compressor, which makes an almost dieseling sound). The indoor fan is a separate circuit from the compressor.

Aug 26, 2013 | Bryant Heating & Cooling

2 Answers

I have a Bryant AC when it gets hot the fan stops, when it cools down the fan starts back again.


Hi,
The fan motor is going bad... replace the motor...
Here is a tip about troubleshooting your air conditioner...
There are many things that can cause your air conditioner not to cool...

AirConditioner Trouble - Review the Possibilities

heatman101

Jul 12, 2011 | Bryant Heating & Cooling

1 Answer

MY BRYANT AIR CONDITIONER OUTDOOR AND IN DOOR FANS ARE RUNNING BUT COMPRESSOR MAKES A CLICK NOISE


If the compressor is not clicking on then the relay or the capacitor is defective. Remove the unit out if the compressor is not working and check the relay unit , if the contacts are good , the check or replace the capacitor.
If however the comprssor is not holding on , the current drain must be checked using a clamp tester . if high the compressor can be faulty and might need an overhaul.

Sep 01, 2010 | Bryant Heating & Cooling

1 Answer

Bryant model 594DNO24-E Air out of vents not cool, fan is not moving on AC unit.


I think you are talking about the outdoor unit so see if you can hear the compressor running. If it isn't running then set the thermostat so that the unit is not running and give the pressure time to come down.(15mins-30mins) Discharge pressure will build up if the fan isn't running and cause the compressor to shut down that's the reason for doing this. After this set the thermostat to call for a/c then see if the compressor is running. If it isn't first check your circuit breaker or disconnect or fuses. One of these should be located close to the outdoor unit. If you have power and it's not running then look at the contactor to see if it is pulled in. The contactor supplies both the fan and compressor. After that then check you capacitor. Some use a double capacitor that works the fan and the compressor. Let me know what you find

Jul 04, 2010 | Bryant Heating & Cooling

2 Answers

Have a Bryant AC/Heat pump. Model# 661CJ030-A. Problem: Air conditioner not cooling,fan comes on,there is a click and a hum but compressor doesn't come on to cool. Does thermostat have anything to do with...


Found charge capacitor top ballooned replaced with a universal capacitor found at a local appliance repair shop system works like a champ capacitor is located behind the interior electrical panel after removing the side panel

Aug 19, 2009 | Bryant 463AAC008BA Air Conditioner

1 Answer

Blower wont run


make sure getting 220 v ac on imputs the relay my be bad hook up fan man to power check to see if getting a call from stat to make fan run green to common 24v ac hope this helps

Jun 17, 2009 | Heating & Cooling

Not finding what you are looking for?
Bryant 462AJC021BA Air Conditioner Logo

692 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bryant Heating & Cooling Experts

christian nielsen

Level 3 Expert

358 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Mike Squire

Level 2 Expert

391 Answers

Are you a Bryant Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...