Question about Kyocera Mita FS 1000+N Laser Printer
You asked where I live.
I live in Roma in Western Queensland - about 5 hours drive west of Brisbane. I am happy to pay postage.
Part number is SENXGP1A73A
Tips for a great answer:
May 02, 2013 | Kyocera TASKalfa 180 Copier
Dec 28, 2008 | Kyocera FS-3900 DTN MONO LASER PRINTER
Dec 22, 2008 | Kyocera Mita FS 1000+N Laser Printer
Dec 03, 2008 | Kyocera Printers & Copiers
A solution has been found. Thank you to Steveauh (Townsville)
Kyocera in their wisdom have used a foam insulator on the 3 solenoids that disintegrates over time regardless of use.
- Open the right side of the printer
- Disconnect all connections to engine board
- Remove engine board
- Remove plastic guard (white)
- remove all 3 solenoids
- Replace all pads on the solenoids that come up against stops
Registration Solenoid has 2 pads (1 against the solenoid frame and the other on a stop arm, the others just the frame pad)
- Keep thickness to around .4 - .5mm Too thick on register arm will cause early printing.
And that is it. The arms were being magnetically delayed due the metallic contact. It seems to be a regular problem in this chassis FS1000 to FS1030.
Jun 23, 2008 | Kyocera Mita FS 1010 Laser Printer
81 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: