My dryer lights are on but it wont start. All lights are on except for the mins. to run it! I dont know what to do. Its a new dryer

Whirlpool & Kenmore Dryer Repair #01 - Won't Start or Run ...

? 8:50
https://www.youtube.com/watch?v=2WF71WdGn_g
Oct 19, 2011 - Uploaded by canyonman1963
This one deals with testing and replacing the door switch. ...sears wont work wont spin wont wash wont heat wont start fix repair bad noise noisy ... how to change a 4 to a 3 prong cord, to figuring out my door switch problem.

Dryer Door Switch - How To Replace - YouTube

What to do when your washer won't fill, start or run - YouTube

? 2:00
https://www.youtube.com/watch?v=Atd5YHbRh7M
Jun 20, 2012 - Uploaded by searspartsdirect
So if my washer wont start just call Sears. .... Bad sears mykenmore is only 2 years old, fill take 30 mins,,,wash 50 mins rinse never spin never,, ...

oh oh bad windings on motor usually runs for about 20-30 minutes hen shuts off cant start agin after a half hour?

Could be plug catalytic converter ?fuel filter.

I would need to know what is missing when it won't start to advise you.
You need spark at the right time and fuel to the injectors for it to start.

check the check engine light my dodge was doing that 2 sum bout the cooling system dont knw 2 much bout cars but it dont do it knw just when i drive it bout 45 mins and cut it off it wont started back up for about 45 min

The security system in the new lock cylinder has to be programed to the ecm. To do this you just have to leave the key in the run position for 10 minutes until the security light stops flashing. Hook a battery charger to it when you are doing it because if the voltage goes low during the 10 mins, you will have to start over.

see if the thermal bulb is located in the path of the flame, and if it is you will have to change the gas thermal sensing bulb.

factory immobiliser by the sound of it ,dealer only

The dryer is electric? not gas? If so you may have 110 and 1 side and not on the other. Reset the breaker and make sure you have 110v on each hot leg. You say start button I assume you mean door switch for the light? Have you checked the bulb? If this is already yes to this point open the top up and look at the wires coming to the door switch 1 of them is most likely chewed into by a mouse or something. the light has to have power to it all the time the door is open no power no light because I dont believe it gets any power except from the main power terminals not the timer or anything else .

you need a new start button and switch