I think a need a new ink roller. Where do I get one. Thanks

INK ROLLER REPLACEMENT

If printing is blurry even when the ink roller is in the proper
position, replace the roller.
Ink roller: Type EA-732R

WARNING
APPLYING INK TO WORN INK ROLLER OR USE OF
UNAPPROVED INK ROLLER MAY CAUSE SERIOUS
DAMAGE TO PRINTER.

1) Turn the power off.
2) Remove the printer cover. (Fig. 1)
3) Remove the ink roller by turning it counterclockwise and
pulling it upward. (Fig. 2)
4) Install the new ink roller and press it in the correct position.
Make sure that the ink roller is securely in place. (Fig. 3)
5) Put back the printer cover.

You need to replace the ink roller.
You may download a copy of the manual at http://www.classiccmp.org/dunfield/calc/5032svc.pdf. The ink roller replacement instructions are on page 1.

I need to know where ia can get ink roller for TI 5032 SVC calculator

Ink roller: Type EA-772R
WARNING: APPLYING INK TO WORN INK ROLLER OR USE OF
UNAPPROVED INK ROLLER MAY CAUSE SERIOUS DAMAGE TO PRINTER.
1) Set the power switch to OFF.
2) Remove the printer cover. (Fig. 1)
3) Hold the top of the ink roller and remove the roller by pulling
it toward you and then upward. (Fig. 2)
4) Install the new ink roller in the correct position. Make sure
that the roller is securely in place. (Fig. 3)
5) Put back the printer cover.

You need the IR40T Ink Roller

Try www.fjaproducts.com Nu-Kote NR-78BR ink rollers - worked for me!

Most likely you have a leaking print cartridge (toner cartridge). Does it have the same problem if you use the Manual Bypass tray?

It could also be a worn fuser sleeve that is causing the print defect...the fuser would need replaced in that case.

I think on this one it takes a small ink roller that snaps in palce in the upper left of the printwheels. I think the ink rolls are purple on this model amd I right???

Unless the ink roller that you installed was dried out, usually, the replacement rollers just snap in place and are good to go. Check to make sure there is ink on the roller by either pulling the ink roller out again, and touching it with your finger. If no ink on your finger, you might have received a dried out replacement roller. Also the roller should be somewhat like a sponge. If you push against the sponge and it doesnt spring back and it stays indented, then the roller might also be bad. If you happen to have a bottle of ink for an ink pad, you can try soaking the roller with the ink so the roller is wet, (but not DRIPPING WET) and try it again in the calculator. IF you get some image for a little while, then I would say try a new fresh ink roller.
Hope this helps.

if you calculkator does not print at all try to move a switch to p or print, and you have a ink roller on the printer