Question about Heating & Cooling

2 Answers

I have a SUKI Dehumidifier, euro 20/20, the on/off button stays on and won't turn off and the cont button on humidity % area keeps flashing even though nothing is working... no compressor or fan (no sound at all)... please help me!

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Expert
  • 256 Answers

Good day. Try unpugging the unit and leave for about 5 minutes to reset. Have you had any thunder storms lately in your area?

Posted on Aug 07, 2010

  • bill briefcase Aug 07, 2010

    no just raining heavily

×

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,030 Answers

Sounds like the controller board has gone bad...not much you can do as those are generic units and no parts available.

Posted on Aug 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Goldair dehumidifier GD-2020 has stopped working? 'CONT' light on front panel flashing and now cannot get to operate?


cont button just means continuous run mode . the power light is lit , the full light is out . try reseating the water catch bucket a few times , most machines have a safety that wont allow the thing to operate if bucket isn't just perfect in its slot (you don't want water on your floor )

May 23, 2015 | Dehumidifiers

1 Answer

Why does my 3 week old dehumidifier only flash on and than shuts off ?


This being a dehumidifier it has to be emptied. check the water holding tank, empty it and it should start up again.

Sep 22, 2014 | Kenmore 5230 Dehumidifier

1 Answer

Compressor Works for a while Only On Initial Plug-in


If your machine is equipped with a humidistat it could be faulty and not sensing the humidity level accurately.

Mar 05, 2017 | Danby Premiere DDR5009REE 50 Pint Capacity...

1 Answer

I have a 50 series w/ digital humidity level readout. Recently unit reads the room at 30% humidity so it shuts off unless preferred setting is set to continuous. Can the sensors go bad that measure the...


If the humidity level is at or lower than 30%, the unit won't turn ON, until the reaches 35 - 40%. It's rare for the sensors to go bad. Just keep in mind, the dehumidifier is reading the humidity near the floor, not up at say, chest level. Humidity levels change every season, so this really would not be that unusual. Make sure that your clean the air intake filter regularly. Cleaning and wiping down the coolant coils would be a good idea, too..

Hope this helped you. Please let me know.

May 16, 2011 | Frigidaire FDF50S Dehumidifier

1 Answer

My glodstar DH305T7 dehumidifier wont stay on. Clicks on for a second then turns right off. Now it won't even turn on. There is over 70% humidity in my basement. Only 1 year old.






Hi,


There are many reasons why a dehumidifier will not work or collect water.


Here is a tip that I wrote to help people to figure out what is going wrong with their dehumidifier

Dehumidifier is running but no water is in bucket

heatman101


]==================

Jun 17, 2010 | Goldstar DH304 Dehumidifier

1 Answer

Tyies to Start


Hi,
It could be a bad compressor, circuit board, or maybe even a sensor or dehumidistat...
Here is a tip about dehumidifiers2_bing.gif that run but do not extract water from the air..

Dehumidifier is running but no water is in bucket
http://www.fixya.com/support/r4662409-dehumidifier_running_but_no_water_in

heatman101

May 02, 2010 | Haier 65-Pint Dehumidifier

1 Answer

Control panel explanation


80% means the humidity will be at 80%

You probably want a setting of 50 or 60% if you are trying to keep a damp area dry.

When it is 20 degrees outside, it will probably by below 50% humidity inside so you need more humidity, not running a DEhumidifier.

CONT is for continous running - you probably don't need that setting

Jan 03, 2010 | Dehumidifiers

2 Answers

Damby ddr451


Check your tank. Remove it and look to be sure that there isn't any shipping foam or foreign objects in the area which may be keeping the safety switch open. If the area is clear check the switch to make sure that it is not stuck and it moves freely. If that is OK replace the tank and make sure that it is installed completely and correctly. Try it again. If it still does not work I would take it back to the store and have them check it out under the warranty. Good luck.

Jun 29, 2006 | Danby DDR451 Dehumidifier

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

paulcarew

Level 3 Expert

2514 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Donni Steen

Level 3 Expert

659 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...