Question about Panasonic Televison & Video

Open Question

My dvd hifi sa-vk670 got damaged severely due to lightenings! a technician told me that its power supply and its board is burnt! Where i can buy it so that i can repair it myself!

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: have a panasonic SA-VK670 stereo/dvd player does not work

when use the remote it dosent work and write remote 1

Posted on Jan 18, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Soniq 80cm tv/dvd.2yrs old from jb-hifi.Red light stays on but nothing else happens when turn on from remote or tv.


Sounds like The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/ It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.

Jan 22, 2017 | Televison & Video

3 Answers

Problem with panasonic tv


may due to power variation the transformer is got damaged or power supply wire has got damaged ....
or
may be transformer has got heated fully and it is out...
or
may be the tube is gone....
or may be due to power variation the short circuit might have been occurred and the circuit board has got cracked....

solution : visit the tv technician and discuss problem....

Feb 07, 2008 | Televison & Video

1 Answer

Lightening strike nearby - power surge all worked except onkyo is there a reset button


The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/

Aug 29, 2016 | Televison & Video

1 Answer

Due to thunder strike, my tv power supply board got damaged. How can I get the board for UN40D6500 model


Simply Google it.
"Buy new power supply for UN40D6500"
I got several sites, but you will ultimately have to answer
some questions and decide on the one that best suits
you.

Jan 07, 2015 | Televison & Video

1 Answer

Sa vk670 remote control


HI everybody

please ,some can help me where I can bay original or replacement remote control for Panasonic HIFI system SA-VK 670???
Thank you so much.

Nov 03, 2013 | Televison & Video

1 Answer

After a lightening strick next door last night, my AStar 27" TFT LCDTV Model LTV-2701 will not power up. The Direct TV receiver and the DVD recorder on the same surge protector are fine. Saw the...


Hello,
You need to check the output voltages of the power supply to see which one goes off. It may be due to short circuits some where.If otherwise, Your power supply board is dead, u know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Hope this will help in solving the problem.....

Jun 25, 2011 | Televison & Video

1 Answer

My Panasonic DVD recorder won't turn on after a power out. Another user says that this is common, it may be a burnt diode or a damaged power supply. WOULD TURNING THE POWER STRIP OFF RIGHT AFTER THE POWER...


If the power supply has already suffered the brunt of the surge, it could be an expensive repair, possibly not economical.

Of course, you can submit this recorder to a service centre, and obtain a quote on any repairs/board replacement required, then make a decision afterwards on that basis - yes or no - it's up to you what you do.

Sorry to say the power surge has quite likely destroyed several components in your DVD recorder's PSU beyond economical repair; it would not just be a 'burnt diode'.

However, in the future, if you are worried about likely surges occurring again, you can always switch units off at the power point when you aren't using them (example, overnight when you go to bed or when you go out for more than an hour at a time). This may help prevent expensive damage to other appliances.

Surge protection on your household power (or a surge protected powerboard/strip if that's cheaper and easier to get) is recommended.

Mar 02, 2011 | Panasonic DMR-ES10 DVD Recorder

1 Answer

Panasonic SA-HT920 ''F61'' error message


Hello,

from my experience, I think your player is having a power problem. It must have received excess voltage/irregular power supply which has damaged an IC or capacitor on the power board of the player.

Sometimes this excess power supply might damage the player's main board. This is why it is advice able that you use step down for your player, because DVD player don't need excess power as something might be damaged.

To solve this problem, you will be needing a meter. Open the player, use the meter to read the components on the power board as it will help you discover the component that got damaged and you can then replace the bad component.

But if you do not have the knowledge of fixing this problem, you might be needing the help of a service technician.


Take care.

May 13, 2010 | Audio Players & Recorders

1 Answer

Have a panasonic SA-VK670 stereo/dvd player does not work


when use the remote it dosent work and write remote 1

Mar 16, 2010 | Panasonic Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Televison & Video Experts

 Grubhead
Grubhead

Level 3 Expert

5190 Answers

Demonic-2011
Demonic-2011

Level 3 Expert

472 Answers

The Knight
The Knight

Level 3 Expert

74496 Answers

Are you a Panasonic Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...