Question about Kenwood Car Audio & Video

1 Answer

Removal of car stereo - Kenwood Car Audio & Video

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 96 Answers

Switch off the amp before you pull down the speaker

Posted on Aug 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the stereo on a 1996 mazda mpv


Mazda MPV Dash Trim Removal, Stereo Removal - Auto ...

? 3:38
https://www.youtube.com/watch?v=REoTeVM2S-o
Jul 1, 2013 - Uploaded by Robert DIY
Dash trim removal: 5 minutes. This video will show you how toremove the dash trim piece on the Mazda ...

[PDF]MAZDA 1996-UP MPV - Scosche

www.scosche.com/media/guides/ma381.pdf
164. 1996-UP MAZDA MPV. MINIVAN. RADIO REMOVAL USING SCOSCHE DT-1 TOOLS . FRONT DOOR PANEL. FRONT AND REAR DOOR 61/2" 3-HOLE.

DIY Mazda Car Radio and Speaker Removal, How to Remove

www.carstereoremoval.com/htm/stereoremovalMazda.htm
'96-99* Car Stereo Removal · Ford Stereo Removal Tools Stereo Removal Tools. How To Install and Remove Mazda MPV Van Car Radio and Speaker, '89-95*

Jan 31, 2016 | Mazda Cars & Trucks

1 Answer

How do I remove the radio out of the car for repair?


Cadillac Allante Bose Stereo Removal and Repair - YouTube

? 4:44
https://www.youtube.com/watch?v=gnoCICSMdto
Mar 2, 2009 - Uploaded by Factory Car Stereo Repair
Cadillac Allante Bose Stereo Removal and Repair. Factory Car Stereo Repair ... Cadillac Allante Promo 1988? ... Restricted Mode: Off. History

88-94 Cadillac Radio - YouTube

? 1:44
https://www.youtube.com/watch?v=IQyA-i_G_Lw
Feb 25, 2012 - Uploaded by mrzhvac
Cadillac Fleetwood Car Stereo Removal 1993 - 1996 - Duration: 3:10. Factory Car Stereo Repair 3,801 views. 3:10. 1990 Cadillac Brougham ...

Car Stereo Removal - Cadillac Allante Car Stereo Removal ...




Jan 08, 2016 | 1988 Cadillac Fleetwood

1 Answer

How to can i replace stereo


see this : God bless you
Review your car's owner's manual to see if it has any tips on removing the current stereo. It may have a diagram of the wiring and the area where the stereo is installed.

  • 2 Disconnect the battery to avoid an electrical short while working with the wiring.
  • 3 Use a screwdriver to remove the retaining screws holding in your car stereo. Grab hold of the stereo and pull it toward you to remove it from the dashboard.
  • 4 Get a pair of DIN tools to slip on either side of the stereo, if the stereo connects to the dash using spring clips and bolts. These thin tools slide in easily, release the clips, and allow the stereo to come out easily. You may need to remove dash panels when bolts hold in the stereo. Take out the bolts and screws that hold the stereo in, and then simply pull it out.
  • 5 Look at the wires on the back of your car stereo. You should see 2 wires attached to the stereo. A wiring clip protects the stereo from vibrations and holds the wiring harness steady.
  • 6 Pry the wires up from the stereo and loosen them using a pulling/pushing motion. After working the wires back and forth, you should be able to pull the wires straight out.
  • Sep 28, 2012 | 1996 Toyota Tercel

    1 Answer

    Remove dash on 2002 chevy tracker and remove factory stereo and install new one


    Glad I didn't read this page before I replaced my stereo.

    Remove stereo fascia with three screws - 1 at the top, two on each side of ash tray. Remove 4 screws holding in stereo. Done - takes about 3 minutes.

    Oct 29, 2011 | 2002 Chevrolet Tracker

    1 Answer

    Hi, i have a 1998 chevy malibu and was wondering how to remove the cd player? i wanted to install a new faceplate so i can get sub woofers in there


    Hello,

    Follow the below steps:
    1. Review your car's owner's manual to see if it has any tips on removing the current stereo. It may have a diagram of the wiring and the area where the stereo is installed.
    2. Disconnect the battery to avoid an electrical short while working with the wiring.
    3. Use a screwdriver to remove the retaining screws holding in your car stereo. Grab hold of the stereo and pull it toward you to remove it from the dashboard.
    4. Get a pair of DIN tools to slip on either side of the stereo, if the stereo connects to the dash using spring clips and bolts. These thin tools slide in easily, release the clips, and allow the stereo to come out easily. You may need to remove dash panels when bolts hold in the stereo. Take out the bolts and screws that hold the stereo in, and then simply pull it out.
    5. Look at the wires on the back of your car stereo. You should see 2 wires attached to the stereo. A wiring clip protects the stereo from vibrations and holds the wiring harness steady.
    6. Pry the wires up from the stereo and loosen them using a pulling/pushing motion. After working the wires back and forth, you should be able to pull the wires straight out.
    I hope the above helps.

    Good luck.

    Aug 23, 2010 | Car Audio & Video

    1 Answer

    Car stereo not working


    somthings wrong with your ignition wire run your stereos power on a toogle switch

    Jan 08, 2010 | Kenwood KDC-MP205 CD Player

    1 Answer

    How to remove toyota echo car stereo system


    remove stereo suround which is held in with some stubbin clips then its quiet easy from there

    Oct 18, 2009 | 2003 Toyota ECHO

    1 Answer

    Radio installation in 1983 dodge ram van


    remove screws from dash face, remove dash face. two 10mm bolts hold stereo in place,remove bolts, gently pull stereo out. unplug stereo. install new stereo by reversing the directions

    Oct 19, 2008 | 1983 Dodge Ram Wagon

    Not finding what you are looking for?
    Car Audio & Video Logo

    Related Topics:

    16 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kenwood Car Audio & Video Experts

    xxxxxx xxx

    Level 3 Expert

    4862 Answers

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8274 Answers

    Are you a Kenwood Car Audio and Video Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...