Question about Sevylor 48 in Inflatable River Tube

1 Answer

Sometimes my tube looses air it does not do this all the time whats the problem?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Although you may not noticed, there may be a slight leak somewhere within the tube. Take some dish soap, and roll the tube and see if any air bubble comes out of the trim area, if there are tiny bubbles coming out, then its time for a new one.

Posted on Aug 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a ford windstar 2001 it sputters or chugs at idle. Sometimes I have to shut it off a few times for it to stop. Any ideas?


Is the check engine light on? I really need more info on your veh. Eng. size, etc. You might have a look at the cold air intake tube, It could have a crack in it or be loose where it mounts to throttle body or air cleaner( could be drawing cold air in where it's not suppose to)If you can get me more details we can get to the bottom of your troubles, Hope this helps, Randy 6/2/15 Hi Shannon, Ok you had it checked and they said it was a sensor, If you can get me that code# we may be able to get to the bottom of your problem. Also just a little advise, I have been a mechanic for 40 years when it comes to Drivability Problems(check engine light) Please don't take your vehicle to AutoZone or any other "PARTS" store that calms to be able to diagnose your check engine light, Remember what they do, they sell parts....95% of the time the check engine light comes on is because of a emission related problem, meaning fuel related, ignition related, timing related. And some of these can be extremely costly to your engine, RE: Catastrophic engine failure. 1 injector or even a coil on plug going bad can destroy your engine, The auto parts store don't have the knowledge or tech. training to diagnose Drivability problems. They will read codes with a code reader not a scanner and then give you a piece of paper on how to repair it. Drivability techs spend yrs of training and money to diagnose these problems in todays cars. Just a little piece of mind take it to an expert.

May 31, 2015 | 2001 Ford Windstar

1 Answer

My 2001 econoline van stopped blowing air through the air ducts.A/c's working great, but no air flow.


Either the blower isn't working or the air mixer box is faulty (usually a loose or broken wire or small air tube came off). Sometimes a linkage comes off or brakes.

Oct 01, 2013 | Heating & Cooling

1 Answer

I have Jacuzzi whirpool, and used for 10 years. now even push air switch to blow air through jets, but they do not work. What parts or where I should check it up to find anything wrong ??


The tubing is most likely swollen and loose or even fallen off the bottom of the air switch or off of the back of blower motor. Time to replace tubing.

Aug 31, 2011 | Home

1 Answer

Starts turns on for 10sec turns off starts again step on gas pedal but turns off replaced gas filter


Check the large diameter tube going from the intake manifold to the mass air flow sensor. Sometimes this tube vibrates loose depending on if the last person that worked on it remembered to tighten the clamp holding it on.

hvguy_9.jpg

Feb 09, 2011 | 2000 Chevrolet Suburban

1 Answer

Outside temp is reading 135 degrees car shakes when u break have new breaks and rotors and shuts off when going in to turns or break for a period of time


Check your air intake tubes if there even slightly loose your car will stall also if it has the (MAF) MASS AIR FLOW SENSOR on the intake it could be the problem this is around $50-100 bucks. But it sounds like the air intake tubes are loose you may also would want to change the air filter it could be dirty and plugged up,

Good Luck!

Feb 07, 2010 | 1998 Cadillac DeVille

1 Answer

06 hummer sun roof drain hose is draining into passenger side floor board, hose has come loose in front panel


doesn't mean it came loose, it could be plugged. Mine did the same thing. I had to use compressed air into the hole in the catch pan of the sunroof and blow the tubes clean, but then had to remove paneling around sunroof to reconnect tubes after the air separated the tubes from the sunroof. It was no big deal, but took a little time.

Feb 04, 2010 | 2009 Hummer H3

1 Answer

1993 eagle talon with 2L non torbo rough idling


This is a two part problems.

Part 1

Intake manifold and vacuum lines leak. It will take time to locate.
Carb, cleaner trick can save you 1/2 the time.

Part 2

Air intake tube leak.
It's easier to fix.

Locate air flow sensor.

Your problem can be the plastic tube between air flow sensor and engine intake opening.

The ECU computer read the air temp and density but the leaky tube ADDED more air and colder temp air into the engine.

WRONG data to ECU!

Seal the tube then take on the vacuum when you have time.

MAP and TPS can also be at fault.


Jul 15, 2009 | 1992 Eagle Talon

3 Answers

2001 mazda protege keeps stalling


my 2001 mazda protege starts hard, idles low and high at various times (never normal) and it acts as though its going to stall at all times. sparks and wires are changed no help, changed air filter no help. any idea on what to do?

Mar 26, 2009 | 2001 Mazda Protege

1 Answer

GE 27GT722 Picture problem


Regarless of the reason I will give you ,call a service tech for an estimate since is the safe way to correct the problem. First when you loose the pix put your forearm in the face of picture tube and if the hair in your arm stands up is a good sign because you are not loosing high voltage to the picture tube but if the hair does not stand up it means the crt looses high voltage and for that you need a service tech to troubleshoot.The other reason might not be as expensive If you have high voltage by doing the previus test it might just be a loose conection in the crt board.Do not remove the back cover unless you know what are you doing.Is not safe.

Sep 14, 2006 | GE 27GT722 27" TV

Not finding what you are looking for?
Sevylor 48 in Inflatable River Tube Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sevylor Sport & Outdoor - Others Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

kakima

Level 3 Expert

102366 Answers

Brad Brown

Level 3 Expert

16166 Answers

Are you a Sevylor Sport and Outdoor - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...