Loaded with chilled product yesterday afternoon. this morning had 40 deg in back of shelves and 56 deg at front of shelves. discharge air from back panel is around 33 deg. how con i get the product colder and more even?

Coolant temp sensor? These can be tested in cold, then hot water to see range of resistance.

Use the humidity slide control on the veggies drawer to control the amount of air entering the drawer/s...hope it helps... cheers

Good morning, afternoon, evening or night; whatever time of day you are viewing this solution. Thank you for choosing FixYa to help find this. You have a Dell computer and you need a product key for Microsoft Office Word 2007? Here's a product key that you can try.

GRH4B-HKXXP-WM4MF-YR4K6-BBQJM

If this product key is not valid, reply back to this solution post. Thank you for choosing FixYa as your one-stop solution spot for questions, concerns, problems and request. Have a good morning, afternoon, evening or night; whatever time of day you are viewing this solution post.

on my wd1000 i removed back cover and on top left side there is a electric/electronic component,i noticed a slight burn mark where one of the connections were.I cleaned and crimped it tighter and it has been fine ever since!

No solution but same problem. However mine intermittent. It will come on and run the passenger side speakers and then shut off. All panel displays are on. Next day same thing. I think it has something to do with weather. When it is below 30 deg it doesn't work. When it gets 45 deg and up it works somewhat. It sounds like a bad circuit board connection.

Remove the window unit and dissasemble,and clean it out,careful not to bend the fins on the condense and evaporator,but clean them out,and the inside of the unit also,then see what happens,if the problem persist,then find the probe on the evaporator and move it away from the evaporator until the compressor stays on longer.

More then likely the washer control panel has failed.

check oil level may need oil and filter change radiator could also be dirty they clog up after awhile should be washed out with a hose often

Hello sir; that's toner motor defective , replace it! the parts no. is
41309035000

does it go to cold after a while its ok if not there is a bad switch some were