Hi I don't remember my admin password of the Sony

Go in menu (tools) and enter on the remote control "72". In the service menu choose reset the system. This should being you back to the original state.

Look at this link for details.

Sony PCS XG80 password reset Video conferencing Telepresence Forum

it will need a software, you can contact me
india, 9310201020 [email protected]

Have you checked to see if your router has a small reset button? This may reset it to factory settings and possibly reset the password also.

Your default password is listed on the bottom of your router. turn it over and find your wep or s/n number listed on it and thats your password.

1720 TCP 2253-2263 TCP 49152-49239 UDP
Best Regards,

Hello there..

If you forgot your password you need to reset the router, just remember that you need to reconfigure the router from scratch if you do reset it.

Here is how you reset the router:

. Turn off the router 2. Locate the Reset button on the back of the router.
3. Use a paper clip to press the Reset button and power on.
4. Hold for about 5 seconds (don’t hold too long) and then release. (Or, release when M1 and M2 flash at the same time.)
5. After you have completed the above steps, the router will be reset to the factory default settings


Now you just need to log on to the router using the default admin password and username(Usually username:Admin Pasword:Admin ) and reconfigure the router and set new password.


Kind regards
Andrea

START NEW ACCOUNT,NO PASSWORD NO GO,SORRY,MATRICK AND HELLO GOOD LUCK.

Hello Richard,

The default username is ADMIN and password is PASSWORD, if this does not work then you have to reset the router to factory settings. To do this just press the small recessed button on the back of the router right next to the antenna. Hold the button in for about 10 seconds until the power light flashes, release the button and the router will reset to factory settings. Wait about 15 seconds and you can log in to it at 192.168.1.1 with the above user and password. I hope this helps, if so please rate my solution.

Thanks,
Buddy
Corporate Computer
Over 21 years repairing PCs and printers

1. Access the Setup menu as follows:
Press and hold the MENU button on the remote commander.
2. Select Dial using the �� button on the remote commander.
3. Access the Service menu as follows:
Press 7 then 2 on the remote commander (without pressing the
PUSH ENTER button).
The Service menu appears. (See Figure 1.)
NOTE: To cancel Service mode and return to the Setup menu,
select Cancel using the arrow buttons, and press RETURN

Clear setup and FINISH

Bye Zamani Ali
[email protected]

Reset password sony pcs-1
1. Access the Setup menu as follows:
Press and hold the MENU button on the remote commander.
2. Select Dial using the �� button on the remote commander.
3. Access the Service menu as follows:
Press 7 then 2 on the remote commander (without pressing the
PUSH ENTER button).
The Service menu appears. (See Figure 1.)
NOTE: To cancel Service mode and return to the Setup menu,
select Cancel using the arrow buttons, and press RETURN.