Pmp3000 got hit by lightning 1 leg of the ic2

Visit this page:
http://www.behringer.com/EN/Products/PMP3000.aspx
Or google for:
Behringer Pmp3000 filetype:pdf
Cheers!

You can download Service Manual of Behringer PMP3000 free of cost on below link:
https://www.electronica-pt.com/esquema/audio/behringer-audio/behringer-pmp3000-16040/ Behringer PMP3000

Get an "insert snake" which splits each of two TRS plugs into TWO TS plugs.
Plug the TRS ends into the MAIN INSERT jacks and each of the "TIP" plugs at the other end into inpout jacks of the destroyer. Plug the "RING" plugs into the output jacks of the destroyer. You will need a snake with at least two sets of splits. I use a Behringer PROCOM compressor. For those the TRS plugs go into the channel insert jacks and the tips and ring plugs go to the in and out of each channel of the compressor respectively.

The answer is NO... These jacks need to float driving speakers that are NOT grounded in any way. Connection to channel A with a grounded cable will destroy the channel A amp. Use the 1/4 inch MAIN L & R jacks with balanced lines to active speakers. You can drive several active speakers from each of these jacks.

Your description is inadequate for me to give you help. R1? and what is the 37? and is this on a PMP3000?

Here is schematic for a PMP3000 if that will help:

http://elektrotanya.com/behringer_pmp3000_sch.rar/download.html

There are multiple files compressed... you can use the RAR decompression without paying.
At the website above, scroll down and click on "get manual" to download the service manual. Ignore the other download links.

Di you mean this one? -> http://www.behringer.com/EN/downloads/pdf/PMP1000_P0566_M_EN.pdf

Better way... Connect the main speakers via the Speakons and then put a Power Subwoofer to one of the Monitor connections IF you are not using both stage monitors. If you need to kill the lows to the mains, use the EQ in the PMP-3000.

Use the EQ that is USUALLY on the subwoofer to kill the highs to the sub.

Lot less cables and hardware.

REMEMBER for equipment safety, power ALL interconnected equipment from the same source be it a receptacle or power distribution system.

Powering parts of a system from receptacles strewn around a room is asking for trouble of ground loops and ground faults.

Make sure the slider switch is set to the correct mode.

The TRIM controls must be advanced while the sliders are at 70%.

A common problem is to MISTAKENLY plug 1/3 inch input cable into the Effects Insert jacks instead of the inout IF you use 1.4 instead of XLR inout.

Make sure the channels of interest are NOT muted!

Try this site:

http://parts.digikey.com/1/parts/1015239-igbt-w-diode-600v-75a-to247ac-irgp50b60pd1pbf.html

This is an apparent equivalent.

You want the mon1/mono setting. The center position of the slide switch to use each half of the power amp seperately. Then fiddle with the controls BOTH in the strips and the faders to get desired result.