Hi the buttons are sticking on my finalizer express what should I do

Question edited for clarity.
Question moved from Motorcycles Category.

Sounds faulty. Contact Behringer Support

Product ' US600

Behringer https://www.behringer.com > product
The US600 stomp box offers 5 totally unique Modes: Tremolo Bar, Flutter, Detune, Harmonist and Pitch Shifter. Pitch Shift and Tremolo Bar pitch can be shifted ...

https://www.google.com/search?q=Behringer+us600+%2B+expression+with+Nektar+NX-P

..

Check the following on a VH-11 HiHat.... both cables connected correctly, top playing surface is clear of the inner ring on the lower sensor when in the fully up position, power the module OFF, keep sticks & foot well clear of the HiHat then power ON, finally check the calibration settings (I assume the 15 has that as my TD12 does) If still nogo check on the VDrums forum website....

A common problem with signal-to-noise ratio is having too much gain in the FINAL stages of an audio path, be it analog gain or gain in a digital path. If signals or data is recorded in early stages at too low a level and then normalized in the final stages to bring up to desired level, the dynamic range of the level is sacrificed and the noise level will be large versus the desired signal.

If the buttons are just sticking at their sides in the panel, lube with a tiny bit of CRC 226 on a Q tip. Get the CRC226 at Home Depot in the electrical dept. If the button mechanisms have failed or plastic hinges have broken then replacement is only option. Losing 4 of these to same problem is RIDICULOUS... time to change brands.

I have Behringer Fcb 10 10,but i want to know how expression pedal volume work when connect with GR55.

This was posted under musical instruments with" TC Electronic Finalizer Express..." as the header. It belongs under Automotives or Cars. Hope this helps.

First try the self test function.

If it will not respond I suspect the unit has a power supply problem and will require servicing. This is an internal thing and not DIY unless you have electronic experience.

best way is by hdmi cable if you dont have then scart leads

Hi, befarms. The line 6 FBV Express allows you to select the A B C D in the existing/current bank. You will not be able to change the current bank, disable or enable the effects.
What you can do is, save the preset on the bank number that you desire by holding down the channel button on your amp whether it is A B C or D. Then when the button flashes, you can reinsert or rename the preset and save it to the channel(or bank) that you wish for by scrolling to the bank number and pushing the button on the amp (A B Cor D).
Therefore, you will be able to save your personal setting to a specific bank and channel.

Hope it helps you.

Hi again!

302 Ct St
Brooklyn, NY 11231-4405
Phone: (718) 858-5444 hope it will help you.