Question about Honda Landa PG 3500 PSI Pressure Washer

1 Answer

Cuts off when you try to spray

Runs then the engine cuts off when you try to spray

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 45 Answers

The problem you are describing lies in the engine. In most cases this can be cleared up by doing a tune up. In the meantime you can try choking the engine slightly and see if that keeps it running under pressure. This will usually solve the problem with the smaller GC and GX series Honda engines until you can do the general maintenance.

Aron Kerr
Landa Northwest

Posted on Feb 13, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1986 Pontiac Firebird was running fine then just stopped running. Fuel pump or what?

Fuel pressure tester will tell you. Turn on key see if u can hear it . Could be engine sensor as well see if it starts while with spray bottle spray gasoline straight into throttle body while crankin engine see if it starts

Feb 12, 2015 | 1986 Pontiac Firebird

1 Answer

I have a 2004 polaris sportsman 500 when it gets hot it cuts off and back fires

Does the cooling fan ever run when the engine is hot? If not, you may have a problem with the fan thermostat.

For the record, spray carburetor cleaner does no good if it's sprayed on the outside of the carburetor with the engine running. That's not what it's for.

Jul 29, 2014 | Polaris 2004 Sportsman 500 H.O

2 Answers

Starting problem, need to use spray to start engine, showing code p1100

go to this web site, scroll down to code and open page. this will help you with ideas and possible fixes

Sep 19, 2013 | 2001 Ford Ranger Regular Cab

1 Answer

My 1998 bmw 740i is idling up then down several times before cutting off and it hesitates before cutting off when I try and drive it

Possibly MAF - (Mass airflow sensor). Check and clean sensor and connection clamps. Google it for location on your engine/vehicle model. Test: with the engine running, spray carb cleaner around it lightly. if engine smoothes out, then you located your problem. You can find them on ebay.

Feb 16, 2013 | 1998 BMW 7 Series

1 Answer

My nissan sentra 1987 stops, stalls and cuts off engine

Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 28, 2012 | 1995 Nissan Sentra

1 Answer

1995 Golf gti cuts out, wont start after. Runs fine one day, another cuts out constantly. Not ECU relay or fuel pump relay

Could be the ignition coil. Get a spray bottle and put some soapy water in it and spray the wires 7 coil while the engine is running. You will find your problem.

Jan 13, 2010 | 1996 Volkswagen Jetta

1 Answer

2004 Ford Taurus engines cuts out when it snows or

You could have a cracked coil. Get a spray bottle and put some water in it. Since the engine cuts out when running, start the car up and spray water around the coil.

If that is not the problem work your way around the wiring with a water spray. There can be a small sensor in the front of the air intake which is an air temp sensor.

You can go to Autozone or Oreillys for a free scan. There may be a record of the defect in the computer within 30 or so starts. Then the record vanishes.

Dec 09, 2009 | 2004 Ford Taurus

2 Answers

Lancer not getting enough fuel and cutting out

It might be the fuel filter needs to be changed and it's cutting off flow. Other wise you'll have to look at the pump or injectors.

Oct 18, 2009 | 2002 Mitsubishi Lancer

1 Answer

'84 Ford Ranger cuts off after about 30 mins of driving.

sounds like the auto choke isnt turning itself off properly but to be totally honest i would need this to happen when i test drive it to diagnose it correctly .

Sep 01, 2009 | 1984 Ford Ranger

1 Answer

Can I clean my Maf sensor and throttle body myself on a 2000 pontiac grand prix GTP? What are the steps? Is it necessary on 94,000 miles.

Yes it will help car run better. Take off any hose that goes to card so that you can see down throttle bore. Start car. Grab throttle linkage and figure out how to move it so that you can make the engine go faster. Begine to spray inside throttle body using little red hose that came with carb cleaner. While you are spraying the engine will try to cut out move the throttle linkage to speed up the engine so it won't cut out. Keep spraying all around inside and outside throttle bore.

Aug 07, 2009 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
Honda Landa PG  3500 PSI Pressure Washer Logo

Related Topics:

388 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Garden Experts

John Trevino

Level 3 Expert

1388 Answers


Level 3 Expert

2528 Answers


Level 3 Expert

81285 Answers

Are you a Honda Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides