Question about Ovens

1 Answer

How do i connect the gas pipe to the ck404 kenwood oven

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 277 Answers

You need someone from the Gas Co, because if something goes wrong.. Your insurance will cover the Gas Instaler but not a Home Installer
Do you understand?

Posted on Jul 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Snake like metal pipe in bottom of oven, gas escaping from the conectors to in which the gas flows. Is there a sealent like a plummbers tape or is the conector and snake pipe bad?

no have to change out the line that's leaking.don't mess with gas by trying to tape it up,you could end up blowing up your house,even if the part is expensive change it out!!!!!!! or you'll go BOOM

Apr 30, 2011 | Magic Chef 9522 Electric Double Oven

1 Answer



There can be a number of things causing that...
Is the oven vented? If so then is there a good cap on the pipe?? is the vent pipe high enough above the roof line?
Is there a draft diverter at the back of the oven where the pipe hooks on? A direct connection can cause this...
Is there a vent hood in the room that the oven is in??? Is there enough makeup air, or is the vent blower pulling air back down the stack?
Is the main burners "pulling" the pilot flame away from the thermocouple?
Is the "hood" on the pilot flame adjusted properly to keep the flame on the thermocouple?
Is the thermocouple positioned in the flame properly?
Is the thermocouple correctly tighten into the gas valve?

These questions are what I would be looking for if I was troubleshooting that appliance...


Dec 09, 2010 | Bakers Pride Y-600 Gas Single Oven

1 Answer

Bought new cooker however no user guide its a kenwood ck404 duel fuel double oven 5 ring burner. need to know what symbols on switches are and what they do.

I have a problem with my Kenwood CK404. When I put either oven on (it's a double oven), once it gets hot it starts to make an awful noise. At first I thought it was the fan in the main oven. But it makes the same noise in the small oven, which doesn't have one. Does anyone have any suggestions of what the problem could be? Kind Regards

Aug 21, 2010 | Ovens

1 Answer

No heat in oven

1 fit the fingers properly
2 press oven reset switch
3 connect gas pipe properly and make sure no gas pipe kinks
4 check that all fuses are ok
5 plug an put on
6 wait for few minutes for oven to ignite

May 12, 2010 | Lincoln Conveyor Oven - 1133-000-A

1 Answer

What is the size of the gas intake on the back of the ICV-1
Go to their web site and check out this manual. On page 3 of "Gas Connections", it says that a 3/4" pipe connection is used.

Hope this helps ya.

Jan 19, 2010 | Imperial ICV-1-H Turbo-Flow Electric...

1 Answer

My kenwood ck404 rangestyle main oven has stopped getting hot, but the oven grill still works, is there a second eliment and if so how would I access it? Thank you

my kenwood ck404 duel oven the main oven does not work the light does not come on at all but the other oven works and the light is on
can you help

Jan 01, 2010 | Ovens

1 Answer

Burners and oven will not heat

Something is stopping the gas flow. Turn off gas. Disconnect line from the stove have someone turn on and off the the gas just for a second.(make sure no flame in room). See if gas is available.If not it is the gas line leading into the house somewhere,not the stove.  Follow the piping to the first thng it comes to. Disconnect that line and see if it is open from there back to the connection. If you finally get to the valve,which I dont think you will . You will have to disassemble  or replace it. 

Dec 10, 2008 | Tappan 30IN ELEC IGNa Oven

2 Answers

Oven gas

For safety purposes call gas technician to check your gas pipe. If stove turn off supposed not to smell gas.

Jul 23, 2008 | Frigidaire FGB24S5A Gas Single Oven

Not finding what you are looking for?
Ovens Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ovens Experts


Level 3 Expert

81424 Answers

Sal De

Level 3 Expert

2699 Answers

Craig Butler
Craig Butler

Level 3 Expert

1723 Answers

Are you an Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides