Question about Pride New Mobility Victory XL 4 Wheel Scooter

1 Answer

Scooter will just go in reverse and stay in after

Victry xl4 ,i think 2002 scooter will just go in reverse and stay in after going over bump,then i have to hit it to get it to stop

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

  • Expert
  • 347 Answers

Hello,you need to get someone to refit your forward reverse lever.im disabled myaself.please give me a thumbs rating 1 to 4.i do this as i care not for profit Colin.

Posted on Aug 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does it go-stop-go-stop?


The Controller maybe over heating. another thing that could cause this is loose connection to the battery. Throttle may have broken wire and when you hit a bump looses connection. If you let the scooter sit for 10-15 min. before trying again that could have worked better for you.

Mar 30, 2016 | Pride Victory 4 Wheel Scooter

1 Answer

Cuts out after going over a bump


Hi , 1. It could be a faulty reset switch, 2. controller issues where it drawing to much current , check wiring to the motor and check the brushes , high carbon build up ?? check the wiring from the batteries to the controller looking for loose connections and wiring discoloration .
The best bet would be a faulty reset switch..

Regards
Rob

www.gewizrepairs.co.uk

Dec 15, 2013 | Shoprider Sprinter XL4

1 Answer

My hs-125 scooter stops when it hits a slight bump


There are only two reasons why your scooter would stop when you hit a slight bump...(1) loss of spark and or (2) loss of fuel
More info needed...does it start back up or do you have to crank a lot?
or do you mean "it stops like the brake is on?

Feb 02, 2013 | Ctm HS 125 3 Wheel Power Scooter

2 Answers

I have a sterling diplomat 306 id,


Hello,
Look at the right hand back corner of the bootlid recess, there is a very small steel spike sticking up which is a switch. Sometimes if the scooter goes over a sharf bump, the lid jumps slightly and the switch lifts momentary and puts the brake on. It thinks the lid has been lifted and goes into charging mode.
Switching the power on and off resets the system until the next sharp bump.
The switch is ajustable, or the bootlid needs to be pushed down harder before locking it.
I had this happen on my Diplomat 408i.
Hope this helps.
Regards,
Paul

Jun 01, 2012 | Health & Beauty

1 Answer

Scooter needs to be run forward before it will reverse, also it will stopat times after going over a bump


Sounds like you have a bad motor brush or motor.
I would block up the scooter, remove the seat and rear shroud and inspect the motor while it is running up on blocks. Use a rubber band or tape to hold the throttle lever. Listen for unusual sounds like a whine or growl from the motor, brake or trans-axle. Inspect and wiggle all the wiring, checking for loose connections at the batteries, controller, and front to rear wiring harnesses. See if you can duplicate the problem using a rubber mallet to simulate a bump.
Use a digital voltmeter to check the motor. The brake should read between 40 and 60 ohms and the motor coil resistance should be less than 1.2 ohms. You should pull the caps on the motor brushes and inspect for wear, burning , and melted leads. I have seen the motor brush hang up on the armature in one direction and not the other. You might try rotating the brush 180 degrees on installation to see if this is the case. Large carbon build up inside the motor from brush wear can also cause this. Blow out the brush dust with compressed air when you have the brushes out. There could be another problem related to what you describe and is associated with the throttle potentiometer. If there are dead spots on the potentiometer you could experience the same forward and reverse problem.
The first solution involves replacing a motor/brake, the second involves replacing the throttle potentiometer. Both repairs are straightforward and within the expertise of a good do-it-yourself-er. The parts should be available on-line at a discount. You will save considerable by doing your own labor. Hope this helps.

Dec 15, 2010 | Shoprider Sprinter XL4

1 Answer

My wife inherited a shoprider scooter, but I am not exactly sure how to remove the battery as there was no manual with the scooter. I am not even sure what model it is because the decals are worn...


w beck you have to remove the seat by pulling it out of of the seat post and then remove the shroud or cover by pulling it straight up You will then be able to see the batteries. Your scooter equires two 12 volt batteries probably U1 batteries Hope this helps

Oct 29, 2010 | Shoprider Sprinter XL4 Deluxe

1 Answer

Celebrity XL4, when going up hill, power cuts out. turn key off and back on, scooter will go again for a couple of feet.


Sounds like Overload Cutout ??? Use a Higher Rating Cutout, as going up hill is very hard on Scooters and it also depends on your weight.

Gerry

Aug 11, 2010 | Pride New Mobility Victory XL 4 Wheel...

1 Answer

Wiper harness at the moter 93 1500 chevy sub.


their is a shrot in the colum
if you put in a toggle switch,run directly from the battey and use a nob that way you can cotrol the speed just by turning it

Feb 14, 2009 | 2002 GMC Sierra C/K1500

Not finding what you are looking for?
Pride New Mobility Victory XL 4 Wheel Scooter Logo

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Health & Beauty Experts

Robin Hill
Robin Hill

Level 3 Expert

1271 Answers

wcdoc1953
wcdoc1953

Level 2 Expert

280 Answers

Colin Taylor

Level 2 Expert

347 Answers

Are you a Pride Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...