Question about Panasonic AG-DVX100A Mini DV Digital Camcorder

5 Answers

Warning message Hello, I seem to have done something to my camera - there is a message in red flashing in the middle of the screen that says 'Warning PSD NG' I've been through the menu, but can't see anything that corresponds with the error message. Help! Thank you Clare

Posted by on

5 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 48 Answers

PSD NG is an error dealing with the OIS [optical image stabilization]. It can be fixed, it is not as terminal an error as many have rumored it to be. The caps could be a cause, but very remotely THE cause. You can have the camera sent in to Pani, and they will fix it, and you will get a bill for $300 - $600.

However the main cause for so many of the dvx100 series to have the psd ng error is loose cables. If you feel sure of your self with a screwdriver, tweezers, & forceps, you can make the repair yourself. In simple terms, all you need to do is reseat the ribbon cables. Follow the steps & photos here:

http://www.dvxuser.com/V6/showthread.php?t=172290

I did this repair with great success. It was a nerve wracking two hours, but I have not had the error reappear since. I got the camera from someone dirt cheap, [read 1/4 value], because of the psd ng error. I made the repair & not only have a fully operational unit with beautiful pictures, but I also quadrupled the value of it.

Posted on Jul 03, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Write your answer...PNG ng always appear what can I do to solve it permanently

Posted on Jun 15, 2015

I heard theres no solution... I'm pissed

Posted on May 01, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

PSG IS YOUR IMAGE STABILIZATION CIRCUIT. PSG N/G CAN BE CAUSED BY BAD CAPACITORS ON GYRO BOARD. THEY ARE SURFACE MOUNT 22MF@6V C102,C103. WHEN THEY GO BAD THERE ARE STRAY OSCILLATION THAT PREVENT PROPER OPERATION. WILL AFFECT UNITS EVEN WHEN OIS IS TURNED OFF.. THIS IS A BOOTUP SENSOR PROBLEM. HAVE A SHOP REPLACE THE CAPS, THEY ARE CHEAP, LESS THAN $1.00 FROM DIGIKEY

Posted on Jan 22, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I got the same problem on my Panasonic AG-DVX100A if someone can answer plz !!!

Posted on May 05, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Make a hard left turn and problem comes up on screen and red warning light comes on


If you mean HARD LEFT, maybe you are getting a message from the VDC or BCMthat there is an issue developing in that side. Probably best to take it to a mechanic with knowledge of diagnostics for pontiac. If the warning light comes on often it is probably best done sooner than later before something more serious develops

Jun 04, 2015 | 2008 Pontiac Grand Prix

1 Answer

Why does my camera have a red flashing light on the camera and no signal on the tv


Normally a flashing red light is a warning signal. Perhaps the camera does want to tell you, something is wrong? (Wrong connected, or wrong startup, wrong voltage? who knows?)

Jun 22, 2014 | SWANN Adw-400 Video Surveillance System...

1 Answer

I have a nikon camera and there is a small red hand flashing at the top right hand corner,How can i get this to go away?


Hello

OK, the red hand icon that's flashing indicates that the camera is using a slow shutter speed, and is warning me to be careful to hold it steady.)

So, basically you will just need to increase the shutter speed, and the hand will go away. This setting is usually done in manual mode.

Kind regards
Andrea

Aug 20, 2010 | Cameras

1 Answer

Engine warning light on Dakota 2005 all seems fine?


Hello. that warning light indicates that one or more sensors to one or more systems with in the vehicle is sending a message to the car's computer that something isn't within the proper range of tolerance. Get the car scanned to see what messages it will send to the scanner. A free scan is now available at all AAMCO repair shops, and many auto parts stores. Once you have the scan done, ask them to reset the computer so you do not have that engine warning light remaining on. Joe

Mar 18, 2010 | 2005 Dodge Dakota

1 Answer

What does the flashing red hand in the upper right


The flashing red light is warning you that the shutter speed will be too long for handholding the camera. Put the camera on a tripod or other stable surface, and/or use the flash.

Nov 08, 2009 | Nikon COOLPIX S9 Digital Camera

2 Answers

Flashing E62:10 on screen all the time


I went out and bought a new camera as I was informed my problem had to be sent back to Sony

Apr 09, 2009 | Sony Cyber-shot DSC-T9 Digital Camera

1 Answer

Warning/error message on lcd


Are you still experiencing your problem? I have friends who work with BenQ and I can chase for you if it is still a problem.

Oct 08, 2008 | BenQ DC3410 Digital Camera

1 Answer

Warning massage


I am having the same problem as well. The error message E:91:01 comes up and the flash will not operate.

Aug 14, 2008 | Sony Cyber-shot DSC-W90 Digital Camera

1 Answer

Warning massage


E:91:01 means flash circuit has problem. contact nearest Sony repair shop.

Jun 08, 2008 | Sony Cyber-Shot DSC-S40 Digital Camera

1 Answer

Flash


I am having the same problem. For this indicator, the manual states "Camera movement warning/flash charge". I'm guessing that the flash is no longer functioning. Note you can force the flash to OFF and camera will function without a flash.

Sep 11, 2007 | Olympus Stylus 710 Digital Camera

Not finding what you are looking for?
Panasonic AG-DVX100A Mini DV Digital Camcorder Logo

652 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Video Cameras Experts

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

1671 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

zimcloud

Level 2 Expert

120 Answers

Are you a Panasonic Video Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...