Nelson Sprinkler:  Traveling Tractor Logo

Related Topics:

Posted on Jul 30, 2010

The sprinkler part came flying out of the sprinkler! What can I do?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

  • Contributor 4 Answers
  • Posted on Aug 03, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Joined: Aug 03, 2010
Answers
4
Questions
0
Helped
7808
Points
21

Which part? The arm??? Put it back in and tighten the palstic ens where the arms go in. If it was the whole top piece put it back and turn the arms the other direction, mak esure tractor is going forward.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

T8845pv

You have 120Volt Intermatic sprinkler timer with 24Volt output.
Copy following link for setting sprinkler timer:
http://waterheatertimer.org/pdf/How-to-Set-and-Troubleshoot-Intermatic-sprinkler-timer.pdf
Copy following link for wiring Intermatic sprinkler timer:
http://waterheatertimer.org/How-to-wire-Intermatic-sprinkler-timers.html
Add a comment
lllllllllllll

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

1helpful
2answers

What are some different types of sprinkler systems i could use for my lawn at home?

the most common residential systems are impact spriklers, underground sprinklers, drip sprinklers, or oscillating sprinklers
Jan 28, 2013 • Garden
0helpful
1answer

The timer no longer plays all 3 programmed zones. It play only one.

Three things to look for:
1) If sprinkler turns on-off but doesn't advance to next zone, then Sprinkler Valve is suspect, and timer is good.
2) If sprinkler stays on all the time, or never turns on, then Timer is suspect.
3) If sprinkler turns on-off, but leaks when it's supposed to be off, then Sprinkler Valve is suspect, and timer is good.
http://waterheatertimer.org/Intermatic-trippers-and-parts.html#sprinkler
0helpful
1answer

Do you know where I can get the part for my Nelson Tractor sprinkler? It is the black part that holds the sprinkler.

Hi,

Here is a tip about how to get parts for your traveling lawn sprinkler and also a great article about how traveling lawn sprinklers work.

Traveling Lawn Sprinklers

heatman101

'
;
';;
'
0helpful
2answers
0helpful
1answer

I have an aquamate pump and when i connect it to a continuous sprinkler it stops and starts contiuously

The pump is putting out too much water for the sprinkler.
You can raise the pump shut off pressure at the switch until it is higher than the pressure that the pump runs at with the sprinkler operating. You should have a surge tank connected to the system to give the pump time to balance with the sprinkler.
You can use more water with the sprinkler. This could mean adding another sprinkler or increasing the nozzle size of the existing sprinkler.
Dec 05, 2010 • Garden
0helpful
1answer
0helpful
1answer

I have low water pressure on my rainbird sprinkler system. how can i adjust it?

There are several ways to adjust water pressure on sprinkler systems. First you have to determine if there is a problem with the sprinkler system itself. Things to look for:
1.) make sure that all valves including the main are all the way open.
2.) Inspect the sprinkler heads for clogging. Sediment and debris can also clog your sprinkler heads. Some debris removal may be required.
3.) You make have too many sprinklers operating by one valve. You may need to divide a zone and add another valve to increase water pressure.
4.) If all else fails. You can install a breather intake cap to allow air into your sprinkler system thus increasing GPM (gallon per minute)flow.
5.) one of the biggest mistakes that peopel make is that they undersize the water pipe size to save money. Typically you want to use 3/4" PVC pipe for your main runs and tee into 1/2" PVC for your sprinkler heads.
Good luck. I hope this helps.
Not finding what you are looking for?

154 views

Ask a Question

Usually answered in minutes!

Top Nelson Garden Experts

Brad Brown

Level 3 Expert

19187 Answers

vince

Level 3 Expert

2530 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Are you a Nelson Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...